Jump Starting
Warning !
Failure to follow these directions will cause damage to the electronic components, and can lead to a battery
explosion and severe injury or death. Never lean over batteries while connecting or jump starting, you might
get injured. Battery fluid contains sulfuric acid. Do not allow this fluid to come in contact with eyes, skin or
clothing. In case it does, immediately flush affected area with water, and seek medical help if necessary.
A battery will also produce hydrogen gas, which is flammable and very explosive. Keep flames or sparks
away from battery, avoid improper connection of jumper cables, smoking etc.. Read all instructions before
proceeding.
If the battery is discharged, the engine should be started with jumper cables and the (12 V) battery of another vehicle.
The battery is located in the trunk under the trunk floor.
Proceed as follows:
1
. Position the vehicle with the charged battery so that the jumper cables will reach, but never
let the vehicles touch. Make sure the jumper cables do not have loose or missing insulation.
2.
On both vehicles:
•
Turn off engine and all lights and accessories, except hazard warning flashers or
work lights.
•
Apply parking brake and shift selector lever to position "P".
Important !
3.
Clamp one end of the first jumper cable to the positive (+) terminal of the discharged
battery and the other end to the positive (+) terminal of the charged battery. Make sure
the cable clamps do not touch any other metal parts.
4.
Clamp one end of the second jumper cable to the grounded negative (-) terminal of the
charged battery and the final connection to the negative (-) terminal of the discharged battery.
Important !
5.
Start engine of the vehicle with the charged battery and run at high idle. Make sure the
cables are not on or near pulleys, fans, or other parts that will move when the engine is
started. Allow the discharged battery to charge for a few minutes. Start engine of the
disabled vehicle in the usual manner.
6.
After the engine has started, remove jumper cables exactly reversing the above
installation sequence, starting with the last connection made first. When removing each
clamp, make sure that it does not touch any other metal while the other end is still attached.
Important !
A discharged battery can freeze at approx. +14°F (-10°C). In that case, it must be thawed out before
jumper cables are used. A frozen battery can explode and cause personal injury.
Jumper cable specifications:
•
•
Minimum cable cross-section of 25 mm2 or approx. 2 AWG
Maximum length of 11.5 ft. (3.5 m).
| Categories | Mercedes-Benz C-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Document Type | Free PDF Owner's Manual Download. |
| Tags | Mercedes-Benz C230, Mercedes-Benz C280, Mercedes-Benz C36 AMG, Mercedes-Benz C43 AMG, Mercedes-Benz W202 |
| Model Year | 1995, 1996, 1997, 1998, 1999, 2000 |
| Download File |
|
| Document File Type | |
| Wikipedia's Page | Mercedes-Benz C-Class |
| Copyright | Attribution Non-commercial |
(22 votes, average: 4.14 out of 5)
Automotive readers have rated 1995-2000 Mercedes-Benz C230 C280 C36 AMG C43 AMG W202 Owners Manual 4.1 out of 5.0 based on 22 product reviews. I need a manual. just bought a c280 and there are buttons and things I do not know about.
Mercedes c class 1997 - 2002. I hope it will be of help.
Where is the index? I have questions regarding warning lights
great for those who like to diy and car enthusiast
It would be valuable to the owner this car all over the world
I think it will be useful for us
need Manuel for my girlfriend car. Trying to work on it and need to know fuse panel information!
i think it will be very useful manual guide for me,
help me manual repair c230 A/T 1997
I think it will be good. I like it.
Comments are closed.