Configure SWC (Steering Wheel
Controls) Keys
To program the vehicle to a different mode, use the
following procedure:
1.
Enter the personalization portion of the SETUP
menu following the instructions listed previously.
This feature allows you to customize the functions of the
four steering wheel controls located on the left spoke
of the steering wheel. See Reconfigurable Steering
Wheel Controls (SWC) (CTS) on page 3-7 for
programming information.
2. Turn the TUNE/SEL knob until REMOTE RECALL
MEMORY is highlighted.
3.
Press the TUNE/SEL knob to switch back and forth
between on and off.
Remote Recall Memory
When the mode is turned on, a check mark will
appear next to the feature name.
If your vehicle has the optional memory package, you
will have this feature. When this feature is turned on,
you can recall any previously programmed seat
and mirror controls when the unlock button on the
remote keyless entry transmitter is pressed.
If this feature is selected, Remote Exit Recall or Key In
Recall Memory cannot be selected.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Programmable Modes
Mode 1: ON
Mode 2: OFF
Remote Exit Recall
Before your vehicle was shipped from the factory, it was
programmed to Mode 2. The mode to which the vehicle
was programmed may have been changed since it
left the factory.
If your vehicle has the optional memory package, you
will have this feature. When this feature is turned on, you
can recall any previously programmed exit position for
the driver’s seat when the unlock button on the
remote keyless entry transmitter is pressed.
3-72
| Categories | Cadillac CTS Manuals, Cadillac Manuals |
|---|---|
| Tags | Cadillac CTS 2.8, Cadillac CTS 3.6, Cadillac CTS 6.0 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)