Proceed as follows:
Important!
1.
Position the vehicle with the charged battery so that
the jumper cables will reach, but never let the
vehicles touch. Make sure the jumper cables do not
have loose or missing insulation.
5. Start engine of the vehicle with the charged battery
and run at high idle. Make sure the cables are not
on or near pulleys, fans, or other parts that move
when the engine is started. Allow the discharged
battery to charge for a few minutes. Start engine of
the disabled vehicle in the usual manner.
2.
On both vehicles:
•
Turn off engine and all lights and accessories,
except hazard warning flashers or work lights.
6.
After the engine has started, remove jumper cables
by exactly reversing the above installation
sequence, starting with the last connection made
first. When removing each clamp, make sure that it
does not touch any other metal while the other end
is still attached.
•
Apply parking brake and shift selector lever to
position “P”.
Important!
3.
Clamp one end of the first jumper cable to the
positive (+) under hood terminal of the discharged
battery and the other end to the positive (+) terminal
of the charged battery. Make sure the cable clamps
do not touch any other metal parts.
Notes:
If engine does not run after several unsuccessful
starting attempts, have it checked at the nearest
authorized Mercedes-Benz Center.
4.
Clamp one end of the second jumper cable to the
grounded negative (–) terminal of the charged
battery and the final connection to the negative (–)
terminal (2) of the discharged battery.
Excessive unburned fuel may damage the catalytic
converter.
Jump starting
271
Instruments
and controls
Instrument
cluster display
Technical
data
Operation
Driving
Practical hints
Car care
Index
| Categories | Mercedes-Benz CLK-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CLK55 AMG, Mercedes-Benz W208 |
| Model Year | 2002 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)