SeatingandSafetyRestraints
3.
belt 9 times, ending in the unbuckled state. (Step 3 must be completed
within 50 seconds after the safety belt warning light turns off.)
For the seating position being disabled, buckle then unbuckle the safety
•
After step 3, the restraint system warning light (airbag light) will be
turned on for three seconds.
4.
Within 10 seconds of the light turning on, buckle then unbuckle the
safety belt.
•
•
This will disable the BeltMinder feature for that seating position if it is
currently enabled. As confirmation, the restraint system warning light
will flash 4 times per second for 3 seconds.
This will enable the BeltMinder feature for that seating position if it is
currently disabled. As confirmation, the restraint system warning light
will flash 4 times per second for 3 seconds, followed by 3 seconds with
the light off, then followed by the restraint system warning light
flashing 4 times per second for 3 seconds again.
Safetybeltextensionassembly
If the safety belt is too short when fully extended, there is a 20 cm
(8
inch) safety belt extension assembly that can be added (part number
This assembly can be obtained from your dealer at no cost.
611C22).
Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on
the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended.
Do not use extensions to change the fit of the shoulder belt
across the torso.
Safetybeltmaintenance
Inspect the safety belt systems periodically to make sure they work
properly and are not damaged. Inspect the safety belts to make sure
there are no nicks, tears or cuts. Replace if necessary. All safety belt
assemblies, including retractors, buckles, front seat belt buckle
assemblies, buckle support assemblies (slide bar-if equipped), shoulder
belt height adjusters (if equipped), shoulder belt guide on seatback (if
equipped), child safety seat LATCH and tether anchors, and attaching
hardware, should be inspected after a collision. Ford Motor Company
recommends that all safety belt assemblies in use in vehicles involved in
a collision be replaced. However, if the collision was minor and a
106
2004
Taurus(tau)
OwnersGuide(post-2002-fmt)
USAEnglish(fus)
| Categories | Ford Manuals, Ford Taurus Manuals |
|---|---|
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Automotive readers have rated 2004 Ford Taurus Owners Manual 5.0 out of 5.0 based on 1 product reviews. Great access to needed vehicle manual. Important info at my fingertips for a few keystrokes and an e-mail address - Sweet!
Thank You