Tire repair with the M Mobility system
143
Using the M Mobility system
8. With the ignition key in position 2:
Switch on the compressor and keep
it running for approx. 3 minutes to fill
in the sealant. It does not matter
afterward, what the tire's inflation
pressure is
Turn the system off and disconnect
the hose from the sealant bottle and
the wheel valve. Stow the M Mobility
system in the vehicle.
To repair a flat tire using the M Mobility
system, proceed as follows:
>
>
Fill with sealant, refer to page 143
Distribute the sealant, refer to
page 143
9.
>
Restore tire inflation pressure, refer
to page 143.
Distributing the sealant
Filling with sealant
Right afterward, drive at least about
2 miles / 3 km, so that the sealant is
distributed evenly in the tire.
1.
2.
Shake the bottle of sealant
Screw hose 9 onto the opening of
the sealant bottle
Do not exceed a maximum speed
of 35 mph / 60 km/h. If possible,
keep the vehicle speed above 12 mph /
3.
Twist the dust cap off of the valve on
the flat tire and screw filler hose 2
connected to the sealant bottle onto
the valve
20 km/h.
<
4.
Insert the sealant bottle into the con-
nector on the compressor so that it is
standing upright
Make sure that the system is
switched off, position 0
Inflating tire to correct pressure
1. After driving approx. 1.9 miles/3 km,
pull over at a suitable location
2. Screw hose 9 connected to the com-
pressor directly onto the tire valve
5.
6.
Insert connector 3 into the cigarette
lighter socket inside the vehicle, refer 3. Insert connector 3 into the cigarette
to page 101
lighter socket inside the vehicle
7.
When using the version with the
manometer on the hose: make sure
that screw 8 on the manometer is
tightened down
Online Edition for Part-No. 01 41 0 158 515 - �09/04 BMW AG
| Categories | BMW 3-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW E46, BMW M3 Manuals |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)