Connector, cable and connecting hose are
attached to the bottom of the compressor.
Stow the M Mobility System in the vehicle
again.
Using the M Mobility System
Distributing sealant
To repair a flat tire with the M Mobility System,
proceed as follows:
Immediately drive approx. 2 miles/3 km so that
the sealant is evenly distributed in the tire.
>
>
>
Fill sealant into wheel
Distribute sealant
Do not exceed a speed of 35 mph or
60
km/h. Do not drive slower than 12 mph
or 20 km/h if possible.<
Restore tire inflation pressure
Restoring tire inflation pressure
Filling sealant into wheel
1.
2.
3.
4.
After approx. 2 miles/3 km, pull over at a
suitable location.
Strictly adhere to the specified order, oth-
erwise highly pressurized sealant could
escape.<
Screw compressor hose 9 directly onto tire
valve.
1.
2.
Shake sealant bottle.
Insert connector 3 into cigarette lighter
socket inside the vehicle.
Screw hose 9 onto connection of sealant
bottle.
Correct tire inflation pressure to 29 psi/
3.
4.
Unscrew and remove dust cap from valve of
defective wheel and screw filler hose 2 of
sealant bottle onto valve.
200
kPa. With the ignition switched on:
>
To increase inflation pressure: switch on
the compressor, position I. Switch off
the device briefly to check the tire's cur-
rent inflation pressure.
Insert sealant bottle on compressor hous-
ing so that the bottle is in an upright posi-
tion.
Do not allow the compressor to run
for more than 10 minutes, otherwise
the device will overheat and may be dam-
aged.<
>
To reduce inflation pressure: press but-
ton 8.
if the inflation pressure is not maintained,
drive the vehicle again, refer to Distribut-
ing sealant. Then repeat steps 1 to 4 once.
Using the M Mobility System can be ineffective
with tire punctures larger than approx. 1/6 in/
5.
6.
7.
Make sure that the device is switched off,
position 0.
4
mm. Please contact the nearest BMW Center
Insert connector 3 into cigarette lighter
socket inside the vehicle.
or a workshop that works according to BMW
repair procedures with correspondingly trained
personnel if the tire cannot be made ready for
driving with the M Mobility System.<
With the ignition switched on:
Switch on the device and allow it to run for
approx. 3 minutes to fill the wheel with seal-
ant. It is not important what inflation pres-
sure the tire has after this.
The tire inflation pressure must be at least
29 psi/200 kPa. Otherwise do not con-
tinue driving.<
8.
9.
Switch off device.
Remove connecting hoses from connection
of sealant bottle and tire valve.
33
Online Edition for Part-No. 01 41 0 012 046 - © 04/06 BMW AG
| Categories | BMW Manuals, BMW Z-Series Manuals |
|---|---|
| Tags | BMW E86 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)