FEATURES/OPERATIONS
Auto lock functions
Lights & turn signals
Headlights
Automatic door locks can be programmed by
consumer to operate in 4 different modes.
Doors lock when shifting from Park.
AUTO*
-
-
Headlights
Doors lock when the vehicle speed goes above
about 12 mph.
Parking lights
High beams
-Doors unlock when the ignition key is turned to the
“ACC” or “LOCK” position and driver’s door is
opened.
-Doors unlock when shifting into Park.
Tilt and telescopic steering wheel
Low beams
Length
*if equipped
High beam flasher
Lock
release
Angle
lever
-Automatic light cutoff system Automatically turns
lights off after 30 seconds when any of the doors are
opened and closed with the engine off. Lights may
also be turned off by pushing lock button on remote.
-Daytime Running Light system (if equipped)
Automatically turns on the headlights at a reduced
intensity.
Hold wheel, push lever down, set angle and length,
then return lever.
Note: Do not attempt to adjust while the vehicle
is in motion.
Turn signals
Right turn
Automatic transmission
Lane change
Lane change
Left turn
P
R
N
D
4
3
2
Park
1
Reverse
Front fog lights (if equipped)
Neutral
Drive
Turn
Fourth gear
Third gear
Second gear
Front fog lights turn ON only when the headlights
are on low beam.
L
First gear
Headlight beam level control (if equipped)
1
To shift from PARK, the key must be in the “ON”
Up
Up
position, and the brake pedal depressed.
Downshifting increases power going uphill, or
provides engine braking going downhill. For best fuel
economy during normal driving conditions, always
drive with the shift lever in the “D” position.
8
Down
Down
Higher number will lower the beam.
9
| Categories | Toyota Manuals, Toyota Sienna Manuals |
|---|---|
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)