Preparation
Your BMW has a special nut as body ground
or negative pole.
1.
Check whether the battery of the other
vehicle has a voltage of 12 volts and
approximately the same capacitance in Ah.
This information can be found on the bat-
tery.
2.
3.
Switch off the engine of the assisting vehi-
cle.
Switch off any consumers in both vehicles.
There must not be any contact between
the bodies of the two vehicles, otherwise
there is a danger of shorting.<
5.
Attach the second terminal clamp of the
minus/– jumper cable to the negative termi-
nal of the battery or to the engine or body
ground of the vehicle to be started.
Connecting jumper cables
Connect the jumper cables in the correct
order, so that no sparks which could
cause injury occur.<
Starting the engine
1.
Start the engine of the donor vehicle and
allow it to run for a few minutes at slightly
increased idle speed.
Your BMW has a jump-starting connection in
the engine compartment which acts as the bat-
tery's positive terminal, refer also to the Engine
compartment overview on page 212. The cap is
marked with +.
2.
Start the engine on the other vehicle in the
usual way.
If the first start attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.
1.
Pull the cap of the BMW jump-starting con-
nection up to remove.
3.
4.
Let the engines run for a few minutes.
Disconnect the jumper cables by reversing
the above connecting sequence.
If necessary, have the battery checked and
recharged.
Never use spray fluids to start the
engine.<
2.
3.
4.
Attach one terminal clamp of the plus/+
jumper cable to the positive terminal of the
battery or a starting-aid terminal of the vehi-
cle providing assistance.
Tow-starting, towing away
Observe the applicable laws and regula-
tions for tow-starting and towing vehi-
cles.<
Attach the second terminal clamp of the
plus/+ jumper cable to the positive terminal
of the battery or a starting-aid terminal of
the vehicle to be started.
Do not transport any passengers other
than the driver in a vehicle that is being
towed.<
Attach one terminal clamp of the minus/–
jumper cable to the negative terminal of the
battery or to an engine or body ground of
the assisting vehicle.
232
Online Edition for Part no. 01 41 2 602 099 - © 10/08 BMW AG
Categories | BMW 3-Series Manuals, BMW Manuals |
---|---|
Tags | BMW 323i, BMW 328i, BMW 328xi, BMW 335d, BMW 335xi, BMW E90, BMW E91 |
Model Year | 2009 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(5 votes, average: 3.6 out of 4) Automotive readers have rated 2009 BMW 3- Series 323i 328i 335i XDrive 335d E90 E91 Owners Manual 3.6 out of 4.0 based on 5 product reviews.
Good read.
Nice to have information when you need it
Automotive readers have rated 2009 BMW 3- Series 323i 328i 335i XDrive 335d E90 E91 Owners Owners Manual - English 4.0 out of 4.0 based on 1 product reviews.
I need to find out more about my 323i.
I'm having computer cluster.
The 2009 BMW 3-Series is an enthusiast's dream, yet not-quite-perfect safety ratings, smallish rear seats, and some fussy controls might wrinkle potential buyers' noses
Pour future acquisition