Features of your vehicle
Standard programming
To train most devices, follow these
instructions:
6. To
program the remaining two
HomeLink buttons, follow steps 2
®
through 5.
If there is difficulty locating the training
button, reference the device owner's
manual or please visit our Web site at
www.homelink.com.
2. Firmly press and release the "learn" or
"smart" button (which activates the
"training light").
1.
For first-time programming, press and
hold the two outside buttons,
Rolling code programming
HomeLink
®
Channel 1 and Channel 3
Rolling code devices which are "code-
protected" and manufactured after 1996
may be determined by the following:
Buttons, until the indicator light begins
to flash (after 20 seconds). Release
both buttons. Do not hold the buttons
for longer than 30 seconds.
✽ NOTICE
There are 30 seconds in which to initiate
step3.
•
Reference the device owner's manual
for verification.
2.
3.
4.
Position the end of your hand-held
transmitter 2-8 cm (1-3 inches) away
•
The handheld transmitter appears to
program the HomeLink
®
Universal
Transceiver but does not activate the
device.
from the HomeLink
®
buttons while
3. Return to the vehicle and firmly press,
hold for two seconds and then release
keeping the indicator light in view.
Simultaneously press and hold both
®
the HomeLink and hand-held trans-
mitter button. DO NOT release the but-
tons until step 4 has been completed.
While continuing to hold the buttons
the red Indicator Status LED will flash
•
Press and hold the trained HomeLink
button. The device has the rolling code
feature if the indicator light flashes rap-
idly and then turns solid after 2 sec-
onds.
the desired HomeLink button. Repeat
®
the "press/hold/release" sequence a
second time to complete the program-
ming. (Some devices may require you
to repeat this sequence a third time to
complete the programming.)
slowly
and then rapidly after
4.
5.
Press
HomeLink
and
hold
the
just-trained
To train rolling code devices, follow these
instructions:
HomeLink successfully trains to the
®
frequency signal from the hand-held
transmitter. Release both buttons.
®
button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
activate.
1.
At the garage door opener receiver
(motor-head unit) in the garage, locate
the "learn" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit. Exact location and color of
the button may vary by garage door
opener brand.
5.
Press
and hold the just-trained
HomeLink button and observe the red
®
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
To
program the remaining two
HomeLink buttons, follow either steps
®
1
through 4 above for other Rolling
activate when the HomeLink button is
®
pressed and released.
Code devices or steps 2 through 5 in
Standard Programming for standard
devices.
4
37
| Categories | Kia Magentis Manuals, Kia Manuals |
|---|---|
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)