Infotainment System
75
Navigation go to [destination]
(voice tag), navigation select
[destination] (voice tag): These
commands instruct the system
to select a destination saved under
the voice tag you have stored.
Storing Voice Tags
System help: This command
instructs the system to assist with
display commands.
From the address book entry
information page, press the Add
Voice tag screen button. The system
will respond “Name Please?”.
Radio Commands
The following are radio commands
you can access by clearly stating
the commands exactly as they are
written. The commands are only
available when you are in one of the
following audio modes, AM, FM, or
XM™ (if equipped).
Navigation Help
When a destination is requested
using a voice tag, the system
Navigation Help: This command
instructs the system to assist with
navigation commands.
will state, “Press or say cancel if not
correct”. To cancel this voice tag
destination, using voice recognition,
push and hold the SRCE button on
the steering wheel until you hear a
beep, then say “cancel”. Canceling
voice tag destination by voice
Display Commands
Use the following display commands
to set the display mode.
Radio: This command instructs the
system to turn the audio system on.
Display [set] day [mode]: Use this
command to set the display to
daytime mode.
Radio [band] [select] AM, radio
[band] [select] FM, radio [band]
[select] XM, radio [band] [select]
satellite: These commands instruct
the system to go to either the AM,
FM, or XM (if equipped).
recognition, must be done within
five seconds after the voice prompt.
If you are not currently driving on a
route, the system will automatically
create the voice tag destination as
the final destination. If you are
currently driving on a route, the
system will automatically create the
voice tag destination as a waypoint.
Up to three waypoints can be
created.
Display [set] night [mode]: Use
this command to set the display
to night mode.
Radio [select] (frequency) AM,
radio [select] (frequency) FM:
These commands instruct the
system to go to a specific frequency
on either AM or FM.
Display [set] auto [mode]: Use
this command to set the display to
automatic mode. The system
will change between day and night
mode automatically.
| Categories | Cadillac DTS Manuals, Cadillac Manuals |
|---|---|
| Tags | Cadillac DTS 4.6, Car Navigation System |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.