Practical interior accessories
Integrated universal remote
control*
Programming
The concept
The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various remote-controlled devices,
such as garage doors and gates or lighting sys-
tems. The integrated universal remote control
registers and stores signals from the original
hand-held transmitters.
1
2
Memory buttons
LED
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons 1. After this, the programmed
memory button 1 will operate the system in
question. The LED 2 flashes to confirm trans-
mission of the signal.
Fixed-code hand-held transmitters
1.
2.
Switch on the ignition, refer to page 55.
When starting operation for the first time:
press the left and right memory buttons 1
for approx. 20 seconds until the LED 2
flashes rapidly. The three memory buttons
are cleared.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
safety, refer to page 112.
To prevent possible damage or injury,
before programming or using the inte-
3.
Hold the original hand-held transmitter at a
distance of approx. 4 to 12 in/10 to 30 cm
from the memory buttons 1.
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the pivoting or
travel range of the device being operated. Com-
ply also with the safety instructions supplied
with the original hand-held transmitter.<
The required distance between the
hand-held transmitter and the mem-
ory buttons 1 depends on the system of the
respective original hand-held transmitter
used.<
Checking compatibility
4.
Simultaneously press the transmit key on
the original hand-held transmitter and the
desired memory button 1 on the integrated
universal remote control. The LED 2 flashes
slowly at first. As soon as the LED 2 flashes
rapidly, release both buttons. If the LED 2
does not flash rapidly after approx. 15 sec-
onds, alter the distance and repeat this
step.
If this symbol appears on the package
or in the instructions supplied with the
original hand-held transmitter, you can
assume that the radio remote control device will
be compatible with the integrated universal
remote control.
For additional information, please contact your
BMW center or call: 1-800-355-3515.
You can also obtain information on the Internet
at:
www.bmwusa.com or
www.homelink.com.
5.
To program other original hand-held trans-
mitters, repeat steps 3 and 4.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
HomeLink is a registered trademark of Johnson
Controls, Inc.<
111
Online Edition for Part no. 01 41 2 604 638 - © 02/10 BMW AG
| Categories | BMW 3-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW E90, BMW E92, BMW E93, BMW M3 Manuals |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(5 votes, average: 4.4 out of 5)
Automotive readers have rated 2011 BMW 3-Series M3 E90 E92 E93 Owners Manual 4.4 out of 5.0 based on 5 product reviews. Great car, need a manual. Don't know how to set door settings.
Hello not quite sure what I can review as I can't download until I have written this
It is a very good car with high efficiency. It required a maintenance activity. I am a human
It was easy to order, easy to use pages etc.
Good to find the manual on the web