Features of your vehicle
Rolling code programming
2. Firmly press and release the "learn" or
"smart" button (which activates the
"training light").
Gate operator & Canadian program-
ming
Rolling code devices which are "code-
protected" and manufactured after 1996
may be determined by the following:
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
HomeLink Wireless Control System but-
®
ton (note steps 2 through 4 in the
Standard Programming portion of this
document) while you press and re-press
•
Reference the device owner's manual ✽ NOTICE
for verification.
There are 30 seconds in which to initiate
step3.
•
The handheld transmitter appears to
program the HomeLink
®
Universal
Transceiver but does not activate the
device.
3.
Return to the vehicle, firmly press and
hold for two seconds the desired
("cycle")
your handheld transmitter every
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.
•
Press and hold the trained HomeLink
button. The device has the rolling code
feature if the indicator light flashes rap-
idly and then turns solid after 2 sec-
onds.
HomeLink ®
button
"press/hold/release"
then
release.
Repeat
the
sequence a second time to complete
the programming. (Some devices may
require you to repeat this sequence a
third time to complete the program-
ming.)
Operating HomeLink
To operate, simply press and release the
®
To train rolling code devices, follow these
instructions:
programmed
HomeLink
®
button.
4. Press
and hold the just-trained
HomeLink button and observe the red
®
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
activate.
Activation will now occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
1.
At the garage door opener receiver
(motor-head unit) in the garage, locate
the "learn" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit. Exact location and color of
the button may vary by garage door
opener brand.
5. To
program the remaining two
HomeLink buttons, follow either steps
®
1 through 4 above for other Rolling
Code devices or steps 2 through 5 in
Standard Programming for standard
devices.
If there is difficulty locating the training
button, reference the device owner's
manual or please visit our Web site at
www.homelink.com.
4
46
| Categories | Hyundai Manuals, Hyundai Sonata Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Sonata |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)