If the device cannot be operated after
repeated programming, check whether
Clearing memory buttons
Press both outer buttons 1 for approx. 20 sec-
onds, maintaining pressure until the LED 2
starts to flash:
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button 1 of the integrated universal
remote control. If the LED 2 on the integrated
universal remote control flashes rapidly for a
short time and then remains lit for approx.
All of the memory buttons have been cleared.
It is not possible to clear individual memory
buttons 1.
Roller sun blinds*
2
seconds, then this indicates that the original
hand-held transmitter is equipped with an alter-
nating-code system. In the case of an alternat-
ing-code system, program the memory but-
tons 1 as described in the Alternating-code
transmitters section below.<
Rear window blind
Alternating-code transmitters
Consult the operating instructions of the unit
you wish to set when programming the univer-
sal remote control. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please follow
the supplementary instructions below:
Briefly press the button on the driver's door with
the ignition in radio ready state or higher.
Programming will be easier with the aid of
Roller sun blinds for rear side windows
a second person.<
1.
2.
Park your vehicle within the range of the
remote-controlled device.
Program the integrated universal remote
control as described above in the Fixed-
code hand-held transmitters section.
3.
4.
5.
Locate the button on the receiver of the
device you want to set up, e.g. on the upper
section of its motor.
1
2
3
4
Quarter window blind
Side window blind
Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.
Rear window blind
Press the programmable memory button 1
on the integrated universal remote control
three times.
Switching to the other side
Briefly press the corresponding button with the
ignition in radio ready state or higher.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
The side window blind can not be
extended unless the side window is
closed. If the window is open, the blind will rise
slightly prior to immediately retracting to its
original position.<
If you have any additional questions,
please contact your BMW center.<
112
Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG
| Categories | BMW 7-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 750i, BMW 750Li, BMW 760Li, BMW E65, BMW E66 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)