Integrated universal remote control*
113
3.
Hold the original control device
approx. 2 to 8 in / 5 to 20 cm away
from memory buttons 1.
If the system cannot be operated
after repeated attempts at pro-
on synchronization. Comply with the
following additional instructions when
you program an alternating-code con-
trol device:
gramming, check whether the original
control device is equipped with an
alternating-code system. You can either
check the operating instructions of the
original control device for this informa-
The required distance between
the control device and the mem-
You will find programming easier if
you have the assistance of
another person.<
ory buttons 1 may vary, depending on
the system of the original control device tion, or you can press and hold down
in question.<
the programmed memory button 1 of
the integrated universal remote control. 1. Park the vehicle within range of the
4.
Simultaneously press the command
button of the original control device
If indicator lamp 2 of the integrated uni-
versal remote control flashes rapidly for 2. Program the integrated universal
radio remote controlled device
and the desired memory button 1 on a brief period and then remains on for
remote control as described above in
the section on fixed-code program-
ming
3. Locate the button on the receiver of
the target device, for example on the
drive
the integrated universal remote con-
trol. Indicator lamp 2 starts to flash
slowly. When indicator lamp 2
approx. 2 seconds, the original control
device is equipped with an alternating-
code system. In this case, you have to
program the memory buttons 1 as
flashes rapidly, release both but-
tons. If the indicator lamp 2 does not described below for an alternating-
flash rapidly after approx.
code control device.<
4. Press the button on the receiver of
the target device. Once you have
completed step 4, you have approx.
30 seconds to complete step 5
5. Press the programmed memory
button 1 of the integrated universal
remote control three times.
15 seconds, select a different dis-
tance between the two devices
To program other original control
devices, repeat steps 3 and 4.
Programming an alternating-code
control device
5.
You will need to follow the operating
instructions of the system in question in
order to program the integrated univer-
sal remote control. Read through the
operating instructions for information
The corresponding memory button 1 is
now programmed with the signal of the
original control device.
The corresponding memory button 1 is
now programmed with the signal of the
original control device.
The system can be operated from igni-
tion key position 2.
Please contact your BMW center
if you have any questions.<
| Categories | BMW 3-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 330i, BMW 330xi, BMW E46 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)