The corresponding memory button 1 is
now programmed with the signal of the
original hand-held transmitter.
5. Press the programmed memory
button 1 of the integrated universal
remote control three times.
The equipment can be used in ignition key
position 2.
The corresponding memory button 1 is
now programmed with the signal of the
original hand-held transmitter.
If the device cannot be operated after
repeated programming, check
If you have any additional questions,
whether the original hand-held transmitter
uses an alternating-code system. Here,
either read the instructions for the original
hand-held transmitter or hold down the
programmed memory button 1 of the inte-
grated universal remote control. If the indi-
cator lamp 2 on the integrated universal
remote control flashes rapidly for a short
time then lights up for approx. 2 seconds,
this indicates that the original hand-held
transmitter uses an alternating-code sys-
tem. In the case of an alternating-code sys-
tem, program the memory buttons 1 as
described at Alternating-code hand-held
transmitters.<
please contact your BMW center.<
Clearing memory buttons
Press both outer buttons 1 of the inte-
grated universal remote control for approx.
20 seconds, maintaining pressure until the
indicator lamp 2 starts to flash. All three
memory buttons are cleared.
The memory of individual memory but-
tons 1 cannot be cleared.
Glove compartment
Opening
Alternating-code hand-held
transmitters
To program the integrated universal remote
control, consult the Operating Instructions
for the equipment to be set. You will find
information there on the possibilities for
synchronization.
When programming hand-held transmitters
that employ an alternating code, please
observe the following supplementary
instructions:
Press button. The glove compartment
opens automatically and the lamps come
on.
Programming will be easier with the
aid of a second person.<
1.
2.
Park your vehicle within the range of the
remote-controlled equipment
Closing
Fold the cover up.
Program the integrated universal
remote control as described above at
Fixed-code hand-held transmitters
To prevent injury in the event of an
accident while the vehicle is being
driven, close the glove compartment
immediately after use.<
3.
4.
Locate the button at the receiver of the
equipment to be set, e.g. on the drive
Press the button on the receiver of the
equipment to be set. After step 4, you
have approx. 30 seconds for step 5
Rechargeable flashlight*
The flashlight is located on the left side of
the glove compartment.
The flashlight can remain there continu-
ously.
95
Online Edition for Part No. 01 41 0 157 980 - � 01/04 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 645Ci, BMW E63, BMW E64 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)