You can operate the system when the ignition
key is in position 2.
Clearing memory buttons
Press both outer buttons 1 for approx. 20 sec-
onds, maintaining pressure until the LED 2
starts to flash: All of the memory buttons are
cleared.
If the device cannot be used after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or press the programmed memory button 1
of the integrated universal remote control
longer. If the LED 2 on the integrated universal
remote control flashes rapidly for a short time
then lights up for approx. 2 seconds, this indi-
cates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons 1 as described at Alternating-code
hand-held transmitters.<
The memory of individual memory buttons 1
cannot be cleared.
Glove compartment
Opening
Alternating-code hand-held
transmitters
To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
Press the button. The glove compartment
opens automatically and the lamps come on.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:
Closing
Fold the cover up.
To prevent injury in the event of an acci-
dent while the vehicle is being driven,
close the glove compartment immediately after
use.<
Programming will be easier with the aid of
a second person.<
1.
2.
Park your vehicle within the range of the
remote-controlled equipment.
Rechargeable flashlight*
Program the integrated universal remote
control as described above at Fixed-code
hand-held transmitters.
The flashlight is located on the left side of the
glove compartment.
The flashlight can remain there continuously.
3.
4.
Locate the button at the receiver of the
equipment to be set, e.g. on the drive.
Be sure that the flashlight is switched off
when it is inserted into its holder. Failure
to comply with this precaution could lead to
overcharging and damage.<
Press the button on the receiver of the
equipment to be set. After step 4, you have
approx. 30 seconds for step 5.
5.
Press the programmed memory button 1 of
the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
101
Online Edition for Part-No. 01 41 0 158 445 - � 09/04 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 645Ci, BMW E63, BMW E64 |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 5)
Automotive readers have rated 2005 BMW 6-Series 645Ci E63 E64 Owners Manual 4.0 out of 5.0 based on 2 product reviews. Good car. Runs well. Rim wheels problems.