The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
You can use the system when the engine is run-
ning or when the ignition is switched on.
If you have questions, please contact your
BMW Sports Activity Vehicle Center.<
If the system cannot be operated after
repeated programming, check whether
Clearing memory buttons
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button 1 of the integrated universal
remote control. If the indicator lamp 2 on the
integrated universal remote control flashes rap-
idly for a short time then lights up for approx.
Press both outer buttons 1 for approx. 20 sec-
onds until the indicator lamp 2 starts to flash:
all of the memory buttons are cleared.
The memory of individual memory buttons 1
cannot be cleared.
Cup holders
2
seconds, this indicates that the original hand-
held transmitter uses an alternating-code sys-
tem. In the case of an alternating-code system,
program the memory buttons 1 as described at
the section on alternating-code transmitters.<
Front
Alternating-code transmitters
Consult the operating instructions of the unit
you wish to set when programming the univer-
sal remote control. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please follow
these additional instructions:
Depending on your optional equipment, the
center console contains either one or two cup
holders.
Programming will be easier with the aid of
a second person.<
Passenger side*
1.
2.
Park your vehicle within the range of the
remote-controlled equipment.
Program the integrated universal remote
control as described above at Fixed-code
hand-held transmitters.
3.
4.
Locate the button at the receiver of the
equipment to be set, e.g. on the drive.
Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.
The cup holder for the front passenger is
located beneath the air/heating vent.
5.
Press the programmed memory button 1
of the integrated universal remote control
three times.
1.
Press the trim piece below the air/heating
vent, arrow.
2.
Insert cup.
63
Online Edition for Part-No. 01 41 0 158 448 - � 09/04 BMW AG
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW E83, BMW X3 2.5i, BMW X3 3.0i |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Automotive readers have rated 2005 BMW X3 2.5i 3.0i E83 Owners Manual 5.0 out of 5.0 based on 1 product reviews. Good morning can I see the manual firt before I give a review