positive terminal of the battery or to an aux-
iliary jump-starting terminal of the vehicle to
be jump-started.
Towing and tow-starting the
vehicle
Using the towing eyelet
The screw-in towing eyelet is stored in the
onboard tool kit; be sure that it remains in the
vehicle at all times. It can be attached at the
front or rear of your BMW.
Observe the following instructions in
order to avoid damaging the towing eye-
let or the vehicle: use only the towing eyelet
supplied with the vehicle, and screw it in firmly
until it stops. Use the towing eyelet for towing
on paved roads only. Avoid subjecting the tow-
ing eyelet to lateral loads, e.g. do not lift the
vehicle using the towing eyelet.<
Your BMW is equipped with a special nut,
refer also to the engine compartment over-
view on page 85
3.
With the – jumper cable, connect the nega-
tive terminals of both vehicles.
To do this:
Access to the threaded socket
Attach one cable clamp to the negative bat-
tery terminal or to a suitable ground on the
engine or body work of the support vehicle.
Attach the second cable clamp to the nega-
tive battery terminal or to a suitable ground
on the engine or body work of the vehicle to
be jump-started.
Press out the cover with a screwdriver inserted
in the recess at the top.
Starting the engine
1.
Start the engine of the support vehicle and
let it run for several minutes at a slightly ele-
vated engine idle speed
Being towed
2.
Start the engine of the other vehicle as
usual.
Make sure that the ignition key is in posi-
tion 1, because the steering lock could
otherwise engage and the vehicle could no
longer be steered. There is no power assist
while the engine is off. Therefore, you will need
to exert more force to brake and steer the vehi-
cle.<
If the first start attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge
3.
4.
Allow the engines to run for several minutes
Then disconnect the jumper cables in
reverse sequence
Turn on the hazard warning flashers, if required
by national regulations. If the electrical system
has failed, clearly identify the vehicle being
towed, e.g. by placing a sign or a warning trian-
gle in the rear window.
5.
Depending on the cause of the fault, have
the battery checked and recharged.
Never use spray starter fluids to start the
engine.<
Vehicles with manual transmission
Gearshift lever in idling position.
98
Online Edition for Part-No. 01 41 0 158 704 - © 10/04 BMW AG
| Categories | BMW Manuals, BMW Z-Series Manuals |
|---|---|
| Tags | BMW 2.5i, BMW 3.0i, BMW E85, BMW Z4 2.5i |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)