44
IN CASE OF EMERGENCY
12
D060I01P-GAT
. Lower Vehicle and Tighten
Nuts
Tightening torque:
E060J01A-AAT
After changing wheels
8
Front
Rear
12
to 14 kg.m
to 137 N.m,
12 to 14 kg.m
(118 to 137 N.m,
87 to 101 lbs.ft)
18 to 22 kg.m
(177 to 216 N.m,
130 to 159 lbs.ft)
Minibus,
Van
(118
87
18
to 101 lbs.ft)
to 22 kg.m
Truck
(177 to 216 N.m,
130
to 159 lbs.ft)
HSRFL065
HSRFL064
If you have a tire gauge, remove the
valve cap and check the air pressure.
If the pressure is lower than recom-
mended, drive slowly to the nearest
service station and inflate to the cor-
rect pressure. If it is too high, adjust it
until it is correct. Always reinstall the
valve cap after checking or adjusting
tirepressure.Ifthecapisnotreplaced,
air may leak from the tire. If you lose a
valve cap, buy another and install it as
soon as possible.
Lower the car to the ground by moving
the jack handle up and down. Then
position the wrench as shown in the
drawingandtightenthewheelnuts.Be
sure the socket is seated completely
over the nut. Do not stand on the
wrench handle or use an extension
pipe over the wrench handle.
Go around the wheel tightening every
other nut until they are all tight. Then
double-check each nut for tightness.
After changing wheels, have a techni-
cian tighten the wheel nuts to their
proper torque as soon as possible.
After you have changed wheels, al-
wayssecuretheflattireinitsplaceand
return the jack, jack handle, and tools
to their proper storage locations.
| Categories | Hyundai Manuals, Hyundai H-1 Grand Starex Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Grand Starex |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)