Knowing your vehicle
Rolling code programming
2. Firmly press and release the "learn" or
"smart" button (which activates the
"training light").
Gate operator & canadian program-
ming
Rolling code devices which are "code-
protected" and manufactured after 1996
may be determined by the following:
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
HomeLink® Wireless Control System
button (note steps 2 through 4 in the
Standard Programming portion of this
document) while you press and re-press
•
Reference the device owner's manual
for verification.
There are 30 seconds in which to initi-
ate step 3.
•
The handheld transmitter appears to
program
the HomeLink Universal
Transceiver but does not activate the
device.
3.
Return to the vehicle and firmly press,
hold for two seconds and then release
("cycle")
your handheld transmitter every
the
Repeat
desired
the
HomeLink ®
"press/hold/release"
button.
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.
•
Press and hold the trained HomeLink
button. The device has the rolling code
feature if the indicator light flashes rap-
idly and then turns solid after 2 sec-
onds.
sequence a second time to complete
the programming. (Some devices may
require you to repeat this sequence a
third time to complete the program-
ming.)
Operating HomeLink®
To operate, simply press and release the
To train rolling code devices, follow these
instructions:
4. Press
and
hold
the
just-trained
programmed
HomeLink ®
button.
HomeLink® button and observe the
red Status Indicator LED. If the indica-
tor light stays on constantly, program-
ming is complete and your device
should activate.
Activation will now occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
1.
At the garage door opener receiver
(motor-head unit) in the garage, locate
the "learn" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit. Exact location and color of
the button may vary by garage door
opener brand. If there is difficulty locat-
ing the training button, reference the
device owner's manual or please visit
our Web site at www.homelink.com.
5. To
HomeLink ®
program
the
buttons,
remaining
follow
two
either
steps 1 through 4 above for other
Rolling Code devices or steps 2
through 5 in Standard Programming
for standard devices.
3
81
| Categories | Kia Magentis Manuals, Kia Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)