Features of your vehicle
Calibration procedure
5. Press and hold the MODE button
again for 2~4.5 seconds until the “turn”
appears and “DIR” blinks in the display
and release the button.
6. Drive your vehicle in at least 1 com-
plete (either clockwise or counter-
clockwise) circle at less than 5 km/h (3
mph) within 10 minutes until the com-
pass heading appears.
The compass may not indicate the cor-
rect compass direction when you are dri-
ving in certain areas (tunnel, parking
garage, underground parking lot, near
transformer substation, etc.), and the fol-
lowing may occur:
•
The compass headings become inac-
curate.
•
The compass heading doesn't change
when the vehicle changes direction.
Some compass headings are not dis-
played.
The compass headings are inaccurate
in long distance driving.
the vehicle's compass headings
7. If the vehicle’s compass headings
become
inaccurate again, repeat
steps 1 through 6 above.
•
1VQA2316
1.
2.
Move the vehicle away from any large ✽ NOTICE
•
steel structures or power generating
If you press the MODE button before
the calibration is completed or the vehi-
cle is not rotated within 10 minutes after
“turn” appears and “DIR” blinks, the
correction will be cancelled.
cables or equipment.
If
Check the terrestrial deviation angle
value by pressing and holding the
MODE button for 4.5 seconds until the
become inaccurate continuously, the
compass should be manually calibrated
as follows:
current
terrestrial deviation angle
value appears in the display.
3.
4.
If the terrestrial deviation angle value
is different for your country, set the cor-
rect angle referring to “Setting the
compass
zone” and perform the
“Calibration procedure” again.
Make sure the vehicle windshield
wipers are turned off.
3
113
| Categories | Kia Manuals, Kia Sedona Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
how to remove rear seats