Controls in detail
Useful features
Step 4:
Operation of integrated remote control
i Upon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
̈
Press and hold the signal transmitter
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
̈ Switch on the ignition (୴ page 38).
rage door opener, gate operator or other device. ̈ Select and press the appropriate inte-
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
grated signal transmitter button (2,
or 4) to activate the remote con-
3
̈
While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, indi-
cator lamp 1 will flash slowly and then
rapidly after several seconds.
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Erasing integrated remote control
memory
̈
̈
Switch on the ignition (୴ page 38).
̈
̈
Switch on the ignition (୴ page 38).
Simultaneously press and hold outer
signal transmitter buttons 2 and 4,
for approximately 20 seconds, until
indicator lamp 1 flashes rapidly. Do
not hold for longer than 30 seconds.
Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
̈
Proceed with programming step 5 and
step 6 to complete.
̈
Indicator lamp 1 will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
The codes of all three channels are
erased.
i If you sell your vehicle, erase the codes of all
three channels.
266
| Categories | Mercedes-Benz CLS-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CLS550, Mercedes-Benz CLS63 AMG, Mercedes-Benz W219 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Automotive readers have rated 2008 Mercedes-Benz CLS550 CLS63 AMG W219 Owners Manual 5.0 out of 5.0 based on 2 product reviews. This is exactly what I've been looking for and need. Great info in perfect detail and limited pics help as well.
Great having the manual saved on my tablet versus having to get the hard copy from within the vehicle. It's very thorough and complete, much appreciated
. Ty