Features of your vehicle
LO : Normal wiper speed
HI : Fast wiper speed
✽
NOTICE
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
before using the windshield wipers to
ensure proper operation.
✽
•
NOTICE
OHM048201
OHM048206
When you operate the wipers, if your
vehicle has a problem in any part of
the wiper operation system, the wiper
may operate in the LO mode regard-
less of the wiper switch position. In
this case, have your vehicle checked
by an authorized KIA dealer as soon
as possible.
D200100AHM
Windshield wipers
D200200ASA
Windshield washers
Operates as follows when the ignition
switch is turned ON.
In the OFF position, pull the lever gently
toward you to spray washer fluid on the
windshield and to run the wipers 1-3
cycles.
Use this function when the windshield is
dirty.
The spray and wiper operation will con-
tinue until you release the lever.
If the washer does not work, check the
washer fluid level. If the fluid level is not
sufficient, you will need to add appropri-
ate non-abrasive windshield washer fluid
to the washer reservoir.
MIST : For a single wiping cycle, push the
lever upward and release it with
the lever in the OFF position. The
wipers will operate continuously if
the lever is pushed upward and
held.
• When the ignition key is removed, the
wiper blade may sometimes slightly
move to reduce the deterioration of
the windshield wipers.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at the
same wiping intervals. Use this
mode in a light rain or mist. To vary
the speed setting, turn the speed
control knob(1).
The reservoir filler neck is located in the
front of the engine compartment on the
passenger side.
4
77
Product Specification
Categories | Kia Borrego Manuals, Kia Manuals |
---|---|
Model Year | 2009 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
I want to buy used 2009 Kia Borrego. So I need mannual