Gray
Message for low tire inflation pressure
The system cannot detect a puncture.
The reasons for this are as follows:
The warning lamps come on in yellow
and red. A message appears on the
Control Display. In addition, a signal
sounds.
>
>
TPM is being reset.
Interference from systems or devices that
use the same radio frequency.
>
>
There is a flat tire or substantial loss of tire
pressure.
>
Malfunction.
The system was not reset after a wheel
change and will thus issue warnings at the
last initialized inflation pressures.
Resetting the system
Each time a tire inflation pressure has been
corrected or a wheel or tire has been changed,
reset the system.
Cautiously reduce speed to below 50 mph/
80
km/h. Avoid sudden braking and steering
maneuvers. Do not exceed a speed of 50 mph/
1.
2.
3.
"Vehicle Info"
"Vehicle status"
"Reset TPM"
80
km/h.
Do not continue driving if the vehicle is
not equipped with run-flat tires, refer to
page 220; continued driving could result in a
severe accident.<
Continuing to drive with a flat tire
Possible travel distance with complete tire
pressure loss:
>
With a light load:
1 to 2 persons without luggage:
Approx. 155 miles/250 km
>
With a medium load:
2 persons, cargo area full, or 4 persons
without luggage:
4.
5.
6.
Start the engine – do not drive away.
Start the initialization using "Reset TPM".
Start driving.
Approx. 95 miles/150 km
The tires are shown in gray and "Resetting
TPM..." is displayed.
With a full load:
4 persons, cargo area full:
Approx. 30 miles/50 km
>
After driving a few minutes, the set inflation
pressures in the tires are accepted as the target
values to be monitored. The resetting is com-
pleted automatically as you drive. On the Con-
trol Display, the tires are shown in green and
"Status: TPM active" is displayed again.
Drive cautiously and do not exceed a
speed of 50 mph/80 km/h.
When there is a tire pressure loss, the handling
characteristics change, e.g. there will be
reduced directional stability during braking,
braking distances will be longer, and self-steer-
ing response will change.<
You can stop driving at any time. The resetting
continues automatically when you resume driv-
ing.
Vibrations or loud noises during driving
may indicate the final failure of the tire.
Reduce your speed and bring the vehicle to a
stop; otherwise, tire components may become
detached, which could result in an accident.
Do not continue driving; instead, contact your
BMW center.<
If a flat tire is detected during the reset-
ting process, all tires are displayed in
yellow in the Control Display. The message
"Low tire!" is shown.<
95
Online Edition for Part no. 01 41 2 604 638 - © 02/10 BMW AG
| Categories | BMW 3-Series Manuals, BMW M3 Manuals, BMW Manuals |
|---|---|
| Tags | BMW 328i, BMW 328i xDrive, BMW 335i, BMW 335i xDrive, BMW 335is, BMW E90, BMW E92, BMW E93, BMW M3 Manuals |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)