Maintenance
1.
2.
Open the hood.
Remove the headlight bulb cover by
turning it counterclockwise.
G220102APB
Turn signal light
(Continued)
•
If a bulb becomes damaged or
cracked, replace it immediately
and carefully dispose of it.
1. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
3.
4.
Disconnect the headlight bulb socket-
connector.
•
Wear eye protection when chang-
ing a bulb. Allow the bulb to cool
down before handling it.
Unsnap the headlight bulb retaining
wire by depressing the end and push-
ing it upward.
2. Remove the bulb from the socket by
pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket
5.
Remove the bulb from the headlight
assembly.
❈
Traffic Change (For Europe)
The low beam light distribution is asym-
metric. If you go abroad to a country with
opposite traffic direction, this asymmetric
part will dazzle oncoming car driver. To
prevent dazzle, ECE regulation demand
several technical solutions (ex. automatic
change system, adhesive sheet, down
aiming). This headlamps are designed
not to dazzle opposite drivers. So, you
need not change your headlamps in a
country with opposite traffic direction.
6. Install a new headlight bulb and snap
the headlight bulb retaining wire into
position by aligning the wire with the
groove on the bulb.
3.
Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
4. Install the socket in the assembly by
aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
7.
Connect the headlight bulb socket
connector.
8.
Install the headlight bulb cover by turn-
ing it clockwise.
Position light
1.
Remove the socket from the assembly
by pulling it straight out.
✽
NOTICE
If the headlight aiming adjustment is nec-
essary after the headlight assembly is rein-
stalled, consult an authorized HYUNDAI
dealer.
2. Remove the bulb from the socket by
pulling it out.
3.
Insert a new bulb by inserting it into
the socket.
4.
Install the socket in the assembly by
pushing it in.
7
66
| Categories | Hyundai Manuals, Hyundai i20 Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, i20 |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)