INSTALLING LATCH-RETAINED CHILD SAFETY
SEAT
To install a LATCH-
retained child safety
seat, slide the safety
seat onto the anchor
bars until it engages.
Carefully read and follow
the instructions provided
by the child safety seat
manufacturer.
Lower LATCH anchorage
points are provided at all three
rear seating positions and
are located between the seat
back rest and rear cushion.
The exact position of each
anchorage point is indicated
by the child safety seat
identification tab on the seat.
UPPER TETHER STRAPS
Although LATCH anchorage points
are provided at all three rear seating
positions, you can only use two at the
same time. To seat three children, use a
non LATCH-retained child safety seat in
the middle.
If an upper tether strap is
provided, attach the tether
strap hook to the tether anchor
point located on the back of the
rear seats. If the child seat is
installed on a left or right hand
seat, position the strap so that
it runs over the center of the
Model S head support on the
rear seat. If installed on the
center seat, position the strap
to run over the left hand side of
the head support. Then tighten
according to the child safety seat
manufacturer’s instructions.
When installing two LATCH-retained
child safety seats, you can not install
them adjacent to each other with one
in the middle and the other on the left
(driver’s side).
NOTE: As you tighten the tether
strap, the top of the head rest will deform to prevent the strap from moving
from side to side.
10
| Categories | Tesla, Tesla Model S |
|---|---|
| Download File |
|
| Document Type | Safety Information |
| Language | English |
| Product Brand | Tesla, Model S |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)