What to do in an emergency
Distributing the sealant
Setting the tire inflation pressure
✽ NOTE
11.
Immediately drive approximately 12. After driving approximately 2 The pressure gauge may show high-
2 miles (3 km) to evenly distribute
miles (3 km), stop at a suitable er than actual reading when the
compressor is running. To get an
the sealant in the tire.
location.
13.
Connect connection hose (9) of accurate tire reading, the compres-
the compressor directly to the tire sor needs to be turned off.
valve.
CAUTION
Do not exceed a speed of
0mph (80 km/h). If possible, do
not fall below a speed of 12 mph
20 km/h).
5
14. Connect between compressor
and the vehicle power outlet
using the cable and connectors.
- To reduce the inflation pres-
sure: Press the button (8) on the
compressor.
(
While driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
15. Adjust the tire inflation pressure
to 32 psi (220 kPa). With the igni-
tion switched on, proceed as fol-
lows.
CAUTION
Be careful not to overinflate the
tire and stay away from the tire
when filling it.
- To increase the inflation pres-
sure: Switch on the compressor,
position I. To check the current
Call for road side service or tow-
ing.
inflation pressure setting, briefly 16. Remove the speed restriction
switch off the compressor.
label(0) from the sealant bottle(1)
and place it in a highly visible
place in the vehicle such as on
the steering wheel to remind you
not to drive too fast.
WARNING
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.
6
24
| Categories | Hyundai Manuals, Hyundai Elantra Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Elantra |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)