Features of your vehicle
✽ NOTICE
5. At the garage door opener receiver
(motor-head unit) in the garage, locate
the "leam" or "smart" button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit.
Gate operator & Canadian program-
ming
Some devices may require you to replace
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
HomeLink® Wireless Control System but-
ton (note steps 2 through 3 in the
Programming portion of this document)
while you press and re-press ("cycle")
your handheld transmitter every two sec-
onds until the frequency signal has been
learned. The indicator light will flash
slowly and then rapidly after several sec-
onds upon successful training.
this Programming step 3 with proce-
dures
noted
in
the
"Gate
Operator/Canadian Programming" sec-
tion. If the HomeLink indicator light
®
6.
Firmly press and release the "leam" or
"smart" button. (The name and color of
the button vary by manufacturer).
There are 30 seconds to initiate step
7.
does not change to a rapidly blinking
light after performing these steps, con-
tact HomeLink at www.homelink.com.
®
4.
Firmly press, hold for 5 seconds and
release the programmed HomeLink
7.
Return to the vehicle and firmly press,
®
hold
for
2
seconds
button up to two separate times to acti-
vate the door. If the door does not acti-
vate, press and hold the just-trained
and
release
the
programmed
HomeLink
®
button.
Repeat
the
"press/hold/release" sequence a sec-
ond time, and, depending on the brand
of the garage door opener (or other
rolling code equipped device), repeat
this sequence a third time to complete
the programming process.
Operating HomeLink®
HomeLink
®
button and observe the
indicator light.
To operate, simply press and release the
•
If the indicator light stays on con-
stantly, programming is complete
and your device should activate
programmed
HomeLink
®
button.
Activation will now occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
when
the
HomeLink
®
button is
pressed and released.
HomeLink
®
should now activate your
•
If the indicator light blinks rapidly for
rolling code equipped device.
2
a
seconds
constant
and
light,
then
continue
turns to
with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
4
46
| Categories | Hyundai Manuals, Hyundai Sonata Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Sonata |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)