Features of your vehicle
VOICE RECOGNITION
(if equipped model)
If prompt feedback is in [ON], then the
system will say “Please say a command
after the beep (BEEP)”
5)If a name is not recognized from the
contact list, change it to a more
descriptive name (e.g., use “Grandpa
Joseph” instead of “Pa Joe”).
•
If prompt feedback is in [OFF] mode,
then the system will only say “(BEEP)”
Using Voice Recognition
•
To
[On]/[Off], go to SETUP
[Prompt Feedback]
change
Prompt
Feedback
[System]
Skipping Prompt Messages
While prompt message is being stated
Starting Voice Recognition
Shortly press the
ing remote controller.
key on the steer-
Shortly press the
key on the steer-
ing wheel. Say a command.
✽
NOTICE
The prompt message is immediately
ended and the beep tone will sound.
After the “beep”, say the voice command.
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
Re-starting Voice Recognition
Contact List Best Practices
While system waits for a command
key on the steer-
ing remote controller.
1)Do
not store single-name entries (e.g.,
Shortly press the
“Bob”, “Mom”, “Kim”, etc.).
Instead, always use full names (includ-
ing first and last names) for all contacts
(e.g., use “Jacob Stevenson” instead of
“Dad”).
The command wait state is immediately
ended and the beep ton will sound. After
the “beep”, say the voice command.
2)Do
not use abbreviations (i.e., use
instead of “Lt.” or
“Lieutenant”
“Sergeant” instead of “Sgt.”).
not use acronyms (i.e., use “County
3)Do
Finance
Department”
instead
of
“CFD”).
4)Do
not use special characters (e.g.,
“hyphen -”, “asterisk *”, “amper-
sand &”).
“@”,
4
141
| Categories | Hyundai Manuals, Hyundai Accent Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Accent |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)