2015 Hyundai Genesis Coupe Owners Manual

Maintenance
5.
Maximum permissible inflation
pressure
7. Uniform tire quality grading
Quality grades  can  be found  where
WARNING - Tire age
Tires  degrade  over  time,  even
when they are not being used.
This number  is the greatest  amount     applicable    on    the   tire    sidewall
of air pressure  that should be  put in     between  tread  shoulder  and  maxi-
the tire. Do not exceed the maximum     mum section width.
permissible inflation pressure.  Refer
to the  Tire and  Loading Information
label   for    recommended    inflation
pressure.
Regardless   of   the  remaining
tread,  it  is  recommended  that
tires generally be replaced after
six (6)  years of normal  service.
Heat caused  by hot climates  or
frequent   high   loading   condi-
tions  can accelerate  the  aging
process.   Failure  to follow  this
warning  can  result  in   sudden
tire failure,  which could lead  to
a  loss  of control  and  an  acci-
dent involving serious  injury or
death.
For example:
TREAD wear 200
TRACTION AA
TEMPERATURE A
6.
This number indicates the  maximum
Maximum load rating
Tread wear
load  in  kilograms  and  pounds  that     The tread wear grade  is a compara-
can  be   carried  by  the   tire.  When     tive rating based on the  wear rate of
replacing  the  tires   on  the  vehicle,     the tire when tested under controlled
always use  a tire that  has the same     conditions   on  a   specified  govern-
load  rating  as  the  factory  installed     ment test course. For example, a tire
tire.
graded  150 would  wear  one-and-a-
half times  (1½)  as well  on the  gov-
ernment course as a tire graded 100.
The  relative   performance   of  tires
depends upon  the actual  conditions
of   their   use,   however,  and   may
depart  significantly   from  the  norm
due  to  variations  in  driving  habits,
service  practices and  differences in
road characteristics and climate.
4.
Tire ply composition and mate-
rial
The number  of layers or  plies of rub-
ber-coated fabric in the tire.Tire manu-
facturers also must indicate the materi-
als  in  the  tire,  which   include  steel,
nylon, polyester, and others. The letter
"R" means radial  ply construction; the
letter "D"  means diagonal  or bias ply
construction; and the letter "B" means
belted-bias ply construction.
7
49
Product Specification
Categories Hyundai Manuals, Hyundai Genesis, Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 438 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, Genesis
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field