2015 Hyundai I30 Owners Manual

What to do in an emergency
Jump starting procedure
Do not  connect it  to or  near any  part
moves   when    the   engine    is
cranked.  Make  sure that  there  is  no
contact between  the  bodywork of  the
two  vehicles;  otherwise,  there  is  the
danger of short circuits.
Do not allow the jumper cables to con-
tact anything except the correct battery
terminals or the correct ground. Do not
lean  over   the  battery  when   making
connections.
Push-starting
that
Your manual  transaxle-equipped vehicle
should  not  be  push-started  because  it
might damage  the emission control sys-
tem.
NOTICE
If the battery is discharged, the engine
can be started using a battery of anoth-
er vehicle and two jumper  cables. Only
use  jumper cables  with  fully  insulated
clamp handles.
To prevent personal injury or damage to
both vehicles, adhere strictly to the fol-
lowing procedure.
Vehicles
equipped
with
automatic
transaxle/dual  clutch  transmission  can-
not be push-started.
Follow  the directions  in  this  section for
jump-starting.
CAUTION - Battery cables
WARNING
1.
Make  sure the  booster  battery is  12-
volt  and  that  its  negative terminal  is
grounded.
If the booster battery is in another vehi-
cle, do not allow the vehicles to  touch.
Do not connect the jumper cable from
the negative terminal of the booster
battery to the negative terminal of the
discharged  battery.  This  can  cause
the  discharged  battery   to  overheat
and crack, releasing battery acid.
Never   tow  a   vehicle   to   start   it
because the sudden  surge forward
when the engine starts could cause
a collision with the tow vehicle.
2.
3.
4.
Turn  off   all   unnecessary   electrical
loads.
Connect the jumper cables in the exact
sequence   shown  in   the  illustration.
First  connect   one  end  of   a  jumper
cable to the positive terminal of the dis-
charged battery  (1), then  connect the
other  end to  the  positive  terminal on
the  booster   battery  (2).  Proceed   to
connect  one end  of the  other  jumper
cable  to the  negative  terminal  of  the
booster battery (3), then  the other end
to a solid, stationary, metallic point (for
example,  the   engine  lifting   bracket)
away from the battery (4).
5.
Start the engine of the vehicle with the
booster battery  and let it  run at 2,000
rpm, then start  the engine of the vehi-
cle with  the discharged  battery. If  the
first starting attempt  is not successful,
wait  a   few  minutes   before   making
another attempt  in  order to  allow the
discharged battery to recharge.
If the cause of your battery discharging is
not  apparent,  we  recommend  that  the
system  be   checked  by  an   authorized
HYUNDAI dealer.
6
6
Product Specification
Categories Hyundai Manuals, Hyundai i30 Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 457 pages
Document TypeOwners Manual
LanguageEnglish
Product BrandHyundai, i30
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field