dc_BA.boo Seite 145 Freitag, 2. Dezember 2005 11:07 11
Control systems
COMAND navigation (introduction)
Route guidance after vehicle transpor-
tation
When positioning is complete, route guid-
ance is once again possible using naviga-
tion announcements and route guidance
displays.
i Please note that the update must be allowed
to run to the end in this case. If you interrupt it,
the navigation system will continue to be non-op-
erational.
COMAND has to redetermine the position
of the vehicle if the vehicle has been trans-
ported (e.g. by ferry, by train or after tow-
ing).
Initial use or use following a system
software update
Interrupting the journey during route
guidance
Positioning takes place automatically even
when COMAND is switched off. The dura-
tion varies from one case to another.
In both these cases, the navigation system
must determine the position of the vehicle.
You may have to drive for a while before
precise route guidance is possible.
The following applies if you interrupt the
journey during route guidance and contin-
ue the journey later:
Route guidance may be restricted as fol-
lows during vehicle positioning:
ț
COMAND resumes route guidance au-
tomatically if you continue the journey
within 2 hours.
GPS reception
ț
Navigation announcements, route
guidance displays and displayed street
names are not consistent with the ac-
tual location of the vehicle.
Correct functioning of the navigation sys-
tem depends on GPS reception, among
other things. In certain situations, GPS re-
ception may be impaired, there may be in-
terference or there may be no reception at
all, e.g. in tunnels, in multistory parking ga-
rage or due to snow on the GPS antenna. If
there is snow on the GPS antenna, you
should remove it. The GPS antenna is at
the back of the vehicle roof.
ț
Route guidance is canceled if you con-
tinue the journey after more than
2
hours. It will be necessary to resume
ț
ț
COMAND does not generate navigation
announcements.
the canceled route guidance manually
(
୴ page 192).
Instead of the route guidance displays,
you see the “Off Road” display and a di-
rection arrow. The direction arrow
shows the compass heading to the des-
tination.
i The journey is interrupted if you park the ve-
hicle and switch off COMAND.
The journey is continued when you switch
COMAND back on and start driving on.
145
| Categories | Car Audio and Video, Mercedes-Benz Manuals |
|---|---|
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Automotive readers have rated Mercedes-Benz Command Audio Sound System Owners Manual 5.0 out of 5.0 based on 1 product reviews. NEED TO KNOW HOW TO USE VOICE CONTROL FOR NAVAGTION
THANKS