dc_BA.boo Seite 175 Freitag, 2. Dezember 2005 11:07 11
Control systems
COMAND navigation system (entering a destination)
Moving the map and selecting the des-
tination
If the destination can be attributed, you
Entering predefined destinations
will see the address of the destination.
If not, you will see the display “Destina-
tion from map”.
̈
Select “Navi” Ǟ “Destination” Ǟ
“Stopover”.
̈
Moving map: Slide qmr, omp or
wmx.
If a stopover has already been entered,
you can change it.
̈
Starting route calculation:
Select “Start”, see also (୴ page 171).
̈
Adjusting map scale: rotate ymz.
Rotating clockwise enlarges the map,
rotating counterclockwise reduces it.
̈ Changing: Select “Change Stop-
over”.
Entering a stopover
̈
Selecting a destination: Press n.
You can now select a category.
i When route guidance is active, you can en-
ter a stopover. Stopovers can be predefined des-
tinations from the following predefined
categories:
If the crosshair is located off the edge
of the digital map, a route cannot be
calculated to this destination and you
will see the message “The destination is
located off the map.”.
̈ Selecting a category:
Select category, e.g. “Gas station”.
COMAND first looks for destinations
within the immediate vicinity of the ve-
hicle and near the vehicle’s route. If
there are no destinations available
there, COMAND searches for destina-
tions in an area around the vehicle po-
sition.
ț
ț
ț
ț
ț
“Mercedes-Benz Center”
“Hospital”
̈
̈
Select “OK”.
“Gas station”
Move the map and select a destination
again.
“Parking lot”
“Restaurant”
If the destination is within the limits of
the digital map, COMAND attempts to
attribute the destination to the map,
which can take approximately
However, you can also enter destinations other
than the predefined ones.
If COMAND does not find any destina-
tions, you will see a message to this ef-
fect.
i You can use the stopover function to influ-
ence the route guidance calculation to the main
destination. When you have reached your stop-
over, COMAND automatically calculates the
route to the main destination.
̈
Select “OK”.
2
seconds.
You can now select a different cat-
egory.
୴୴
175
| Categories | Car Audio and Video, Mercedes-Benz Manuals |
|---|---|
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Automotive readers have rated Mercedes-Benz Command Audio Sound System Owners Manual 5.0 out of 5.0 based on 1 product reviews. NEED TO KNOW HOW TO USE VOICE CONTROL FOR NAVAGTION
THANKS