DRIVING YOUR HYUNDAI 2- 3
C030A01E-AAT
!
!
COMBINATION IGNITION SWITCH
To Start the Engine
WARNING:
WARNING:
o
The 2WD Santa Fe is not designed for
off-road use. The 4WD Santa Fe is de-
signed primarily for use on paved roads.
However, occasional use in off-highway
conditions such as established unpaved
roads and non-challenging off-road
trails is allowed. The 4WD Santa Fe is not
designed for blazing new trails, chal-
lenging off-road conditions, or unpaved
hill climbing. Exceeding the conditions
that were intended for the vehicle's pri-
mary design may result in injury or death.
Utility vehicle has a significantly higher
collision rate than other type of vehicles.
Utility vehicle have higher ground clear-
ance and a narrower track to make them
capable of performing in a wide variety
of off-road applications. Specific design
characteristics give them a higher center
of gravitiy than ordinary cars. An advan-
tage of the higher ground clearance is a
better view of the road allowing you to
anticipate problem. They are not de-
signed for cornering at the same speeds
as conventional 2-wheel drive vehicles
any more than low-slung sports cars are
designed to perform satisfactorily un-
der off-road conditions. If at all possible,
avoid sharp turns or abrupt maneuvers.
As with other vehicles of this type, fail-
ure to operate this vehicle correctly may
resultinlossofcontrolorvehiclerollover.
o
In a collision crash, an unbelted person
is significantly more likely to die than a
person wearing a seatbelt.
o
If your Hyundai is equipped with a manual
transaxle, place the shift lever in neutral and
depress the clutch pedal fully.
If your Hyundai has an automatic transaxle,
place the shift lever in "P" (park).
Tostarttheengine,inserttheignitionkeyand
turn it to the "START" position. Release it as
soon as the engine starts. Do not hold the
key in the "START" position for more that 15
seconds.
o
o
C020A01A-AAT
BEFORE STARTING THE ENGINE
Before you start the engine, you should always:
1.
2.
Look around the vehicle to be sure there are
no flat tires, puddles of oil, water or other
indications of possible trouble.
After entering the car, check to be sure the
parking brake is engaged.
Check that all windows, and lights are clean.
Check that the interior and exterior mirrors
are clean and in position.
Check your seat, seatback and headrest to
be sure they are in their proper positions.
Lock all the doors.
Fasten your seat belt and be sure that all
other occupants have fastened theirs.
Turn off all lights and accessories that are
not needed.
When you turn the ignition switch to "ON",
check that all appropriate warning lights are
operating and that you have sufficient fuel.
NOTE:
o
o
o
For safety, the engine will not start if the
clutch pedal is not depressed fully
(Manual Transaxle) or the shift lever is
not in "P" or "N" Position (Automatic
Transaxle).
3.
4.
o
The ignition key cannot be turned from
"ACC" position to "LOCK" position un-
less the shift lever is in the "P" (Park)
position or the negative battery terminal
is disconnected from the battery. To
remove the key, always confirm that the
shift lever is securely positioned in "P"
(Park) (For Automatic Transaxle)
For additional information about start-
ing, see page 2-5.
5.
6.
7.
8.
9.
o
10.Check
the operation of warning lights and all
bulbs when key is in the "ON" position.
| Categories | Hyundai Manuals, Hyundai Santa Fe Manuals |
|---|---|
| Tags | Hyundai Santa Fe 2.4, Hyundai Santa Fe 3.5 |
| Model Year | 2003 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Santa Fe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(5 votes, average: 4.4 out of 5)
Automotive readers have rated 2003 Hyundai Santa Fe Owners Manual 4.4 out of 5.0 based on 5 product reviews. Great to have this for repair jnformation
perfect i love this manual. i require this informaiton to fix my car.
Comments are closed.