44
IN CASE OF EMERGENCY
HEADLIGHTAIMINGADJUSTMENT
26
G290A03P-AAT
G290B03P-AAT
Adjustment After Headlight
Assembly Replacement
Truck
Before performing aiming adjustment,
make sure of the following.
Vertical
aiming
30mm
(1.18 in.) Verticalline
1.
2.
Keep all tires inflated to the correct
pressure.
Place the vehicle on level ground
andpressthefrontbumperandrear
bumper down several times.
Horizontalline
W
Horizontal
aiming
"P"
H
3
. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools). Have the driver or
equivalent weight placed in driver's
seat.
Cut-offline
L
G290A01P-1
Ground
line
5. Open the hood.
H
6. Draw the vertical line (through the
center of each headlight beam pat-
tern)andthehorizontalline(through
the center of each headlight beam
pattern) on the aiming screen.
And then, draw a horizontal parallel
line at 30 mm (1.18 in.) under the
horizontal line.
G290B01L
4
. Clean the head lights lens and turn
on the headlight (Low beam).
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should
becheckedusingtheaimingscreenas
shown in the illustration. Turn on the
headlightswitch.(LowBeamPosition)
Minibus/Van
Horizontal
aiming
7.
Adjust each cut-off line of the low
beamtotheparallellinewithaphillips
screwdriver - VERTICAL AIMING.
1. Adjust headlights so that main axis
oflightisparalleltocenterlineofthe
body and is aligned with point "P"
shown in the illustration.
2. Dotted lines in the illustration show
center of headlights.
Vertical
aiming
8
. Adjust each cut-off line of the low
beam to the each vertical line with a
phillipsscrewdriver-HORIZONTAL
AIMING.
G290A02P
| Categories | Hyundai Manuals, Hyundai H-1 Grand Starex Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Grand Starex |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)