MAINTENANCE
14
9
\
Remove the circlip using a strong pair of circlip
pliers with well fitting 90 angle tips.
the back
clearance diameter of the compressor housing
before removing it from the centre housing.
.
Remove
any
burrs
on
plate
.
..
Hefitting
.!’
16.
17.
Fit a
Place the circlip in position over the centre housing
‘0’ring seal to the back plate.
with the tapered side towards the
vehide.
of the
18.
19.
Offer -up
compressor housing, taking care not
to damage the compressor wheel and back
and line up the scribe marks made before removal.
Secure the housing with the circlip and carefully
tap the ears and inner diameter of
circlip with
flat nosed punch to ensure that it is fully seated in
the groove.
12.
Withdraw the compressor housing complete with
the actuator. To avoid damaging the compressor
wheel withdraw the housing squarely without
tilting the housing.
Cleaning
13.
14.
Remove the ‘0’ring seal from the back plate.
surfaces of the compressor
compressor wheel and back plate with
Clean the
housing,
soft brush and a
compressed air to dry the
back plate.
solvent. Do not use
wheel and
the
damage caused during removal.
and repair any
Connect the actuator rod to the wastegate lever
and secure with the clip.
continued
3
| Categories | Land Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1987 |
| Download File |
|
| Document Type | Workshop Bulletin |
| Language | English |
| Product Name | 2.5 Litre Turbo-charged Diesel Engine |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)