Integrated universal remote control*
117n
relevant system of the original hand-
If the indicator lamp 2 on the integrated
held transmitter used.<
universal remote control flashes quickly
for a brief period and then remains lit up
for approx. two seconds, this indicates
that the original hand-held transmitter is
equipped with an alternating code. In
the case of an alternating-code system,
program the memory buttons 1 as
described at the section on alternating-
code hand-held transmitters.
If you have additional questions, please
consult your BMW Sports Activity Vehi-
cle center or call 1-800-355-3515.
You can also visit this website
4.
Simultaneously press the transmit
button on the original hand-held
transmitter and the desired memory
button 1 of the integrated universal
remote control. Initially, the indicator
lamp 2 flashes slowly. Release both
buttons as soon as the indicator
lamp 2 flashes rapidly If the indicator
lamp 2 does not flash rapidly after
approx. 15 seconds, change the dis-
tance
Programming
5.
To program other original hand-held
transmitters, repeat steps 3 and 4.
1
2
Memory buttons
Indicator lamp
www.bmwusa.com.<
The corresponding memory button 1 is
now programmed with the signal of the
original hand-held transmitter.
Alternating-code hand-held
transmitters
Fixed-code hand-held transmitter
1.
2.
Switch on the ignition
To program the integrated universal
remote control, consult the Owner's
Manuals for the equipment to be set.
You will find information there on the
possibilities for synchronization.
When programming alternating-code
hand-held transmitters, please observe
the following supplementary instruc-
tions:
The device can be operated as of igni-
tion on.
For initial use: press both outer
buttons 1 for approx. 20 seconds,
maintaining pressure until the indica-
tor lamp 2 starts to flash. The three
memory buttons 1 are cleared
Hold the original hand-held transmit-
ter at a distance of approx. 2 to 8 in/
5 to 20 cm from the memory but-
tons 1
If the device cannot be operated
after repeated programming,
check whether the original hand-held
transmitter uses an alternating-code
system. To do so, either read the
instructions of the original hand-held
transmitter or press and hold down the
programmed memory button 1 of the
integrated universal remote control.
3.
The required distance between
the hand-held transmitter and
memory buttons 1 depends on the
Programming will be easier with
the aid of a second person.<
Online Edition for Part No. 01 41 0 158 286 - �04/04 BMW AG
| Categories | BMW Manuals, BMW X5 Manuals |
|---|---|
| Tags | BMW E53, BMW X5 3.0i, BMW X5 4.4i, BMW X5 4.8is |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.5 out of 5)
Automotive readers have rated 2004 BMW X5 3.0i 4.4i 4.8is E53 Owners Manual 4.5 out of 5.0 based on 4 product reviews. this article is so important for x5 owners, thanks for it
very good and very helpful
thank you
lost book.. this is a great service
I own a 2004 BMW X5 4. 4 and the ccv vent valves keep popping off causing the engine to burn oil and grey smoke to become out tge tail pipe.