Child Restraints
‘LATCH’ TYPE CHILD RESTRAINTS
Fitting the restraints
This type of child restraint system should only
be fitted in the two outer seating positions of
the second row seats. Anchor bars built into the
rear seat frame enable ‘LATCH’ type restraints
to be securely attached to the vehicle seat in
these positions only. The anchor bar locations
are shown in the illustration above.
Pass the tether strap over the top of the seat
back and beneath the underside of the head
restraint. Attach the clip on the head of the
tether strap to the appropriate tether anchor
and tighten the tether strap.
WARNING
If the restraint is not correctly anchored, there
is a significant risk of injury to the child, in the
event of a collision or emergency braking.
DO NOT attempt to fit ‘LATCH’ type restraints
to the center seating position - the anchor
bars are designed to hold restraints in the
outer seating positions only.
When fitting this type of child restraint, always
follow the instructions supplied by the
manufacturer of the restraint.
Once the restraint is installed, test the security
of the installation before seating the child.
Attempt to twist the restraint from side to side,
and to pull the restraint away from the vehicle
seat, then check that the anchors are still
securely in place.
H4945
‘
LATCH’ (Lower Anchors and Tether for
Children)
The ‘LATCH’ three-point type child restraint
system complies with Federal Motor Vehicle
Safety Standards and is approved for fitting in
your vehicle.
54
| Categories | Land Rover, Land Rover Discovery |
|---|---|
| Tags | Land Rover |
| Model Year | 2004 |
| Download File |
|
| Language | Bulgarian, English |
| Product Name | Discovery Handbook |
| Product Brand | Land Rover |
| Applicable to Country | International |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)