The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
Programming will be easier with the aid of
a second person.<
1.
2.
Park your vehicle within the range of the
remote-controlled device.
You can operate the system when the engine is
running or when the ignition is switched on.
Program the integrated universal remote
control as described above in the section
Fixed-code hand-held transmitters.
If the system fails to function even after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button 1 of the integrated universal remote
control. If the LED 2 on the integrated universal
remote control flashes rapidly for a short while
and then remains lit for about two seconds, the
original hand-held transmitter uses an alternat-
ing-code system. If it uses an alternating-code
system, program the memory buttons 1 as
described under Alternating-code hand-held
transmitters.<
3.
4.
Locate the button on the receiver of the
device to be set, e.g. on the drive unit.
Press the button on the receiver of the
device to be set. After step 4, you have
approx. 30 seconds for step 5.
5.
Press the programmed memory button 1 of
the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
If you have any questions, please contact
your BMW center.<
Alternating-code hand-held
transmitters
Clearing the memory buttons
To program the integrated universal remote
control, consult the operating instructions for
the device to be set. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please observe
the following supplementary instructions:
Press both outer memory buttons 1 for approx.
20 seconds until the LED
buttons are cleared.
2 flashes: all memory
It is not possible to clear individual memory but-
tons.
Digital compass*
Setting compass zones
Depending on the vehicle's geographic loca-
tion, the relevant compass zone must be set.
1
2
Adjustment button
Display
The display shows you the main or secondary
direction in which you are driving.
102
Online Edition for Part no. 01 41 0 012 346 - © 05/06 BMW AG
| Categories | BMW 3-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 325Ci, BMW 330Ci, BMW E92 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)