Starting engine
When the engine is cold, the exhaust system
has a slightly metallic undertone due to the sys-
tem design.<
Do not run the engine in closed rooms,
otherwise the inhaling of toxic exhaust
gases can cause unconsciousness and death.
The exhaust gases contain carbon monoxide,
an odorless and colorless, but highly toxic gas.
Never leave an unattended vehicle with the
engine running, as such a vehicle represents a
potential safety hazard.
Avoid frequent starting in quick succes-
sion or repeated starting attempts in
which the engine does not start. Otherwise, the
fuel is not burned at all or is burned inade-
quately and there is a danger of overheating and
damage to the catalytic converter.<
Before leaving the vehicle with the engine run-
ning, move the selector lever into the N position
and set the handbrake, otherwise the vehicle
can begin to roll.<
Special starting conditions
Depress the accelerator pedal halfway when
starting the engine in the following situations:
>
The engine fails to start on the first attempt,
e.g. if it is very hot or cold.
When starting the engine, do not press the
accelerator pedal.
>
The engine is started at very low tempera-
tures, below approx. +57/–156, at high
altitudes, over approx. 3,300 ft/1,000 m.
Do not allow the engine to warm up by leaving it
running while the vehicle remains stationary.
Instead, begin to drive immediately at a moder-
ate engine speed.
Switching engine off
Do not remove the remote control from
the ignition lock while the vehicle is roll-
ing, otherwise the steering wheel lock would
engage while steering.
When leaving the vehicle, always take the
remote control with you.
When parking on a downhill incline, apply the
handbrake, as otherwise the vehicle could roll
away.<
Do not press the brake pedal as long as
you do not want to start the engine. The
engine starts immediately when you briefly
press the Start/Stop button with the brake
pedal depressed.<
1.
2.
3.
Apply handbrake.
Move selector lever into a drive position.
Briefly press Start/Stop button.
1.
2.
3.
Depress brake pedal.
A signal sounds when the position N is
engaged and the handbrake is not set when
switching off the engine.
Place selector lever in position N.
Briefly press Start/Stop button.
The system responds by automatically engag-
ing the starter for a certain period and automat-
ically disengaging it as soon as the engine
starts.
Handbrake
The handbrake is primarily intended to prevent
the vehicle from rolling while parked; it brakes
the rear wheels.
If the engine does not start, shift back to
the last selector lever position selected,
refer to the instrument cluster display or the
selector lever. Then select the position N.
You cannot start off with the hood open.
51
Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG
| Categories | BMW 6-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 650i, BMW E63, BMW E64, BMW M6 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4)
Automotive readers have rated 2006 BMW 6-Series 650i E63 E64 M6 Coupe Owners Manual 4.0 out of 4.0 based on 2 product reviews. Bloody m6 roof not working again