The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
You can use the system when the engine is run-
ning or when the ignition is switched on.
If you have questions, please contact your
BMW Sports Activity Vehicle Center.<
If the system cannot be operated after
repeated programming, check whether
Deleting stored programs
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button 1 of the integrated universal
remote control. If the LED 2 on the integrated
universal remote control flashes rapidly for a
short time then lights up for approx. 2 seconds,
this indicates that the original hand-held trans-
mitter uses an alternating-code system. In the
case of an alternating-code system, program
the memory buttons 1 as described in the sec-
tion below on alternating-code transmitters.<
Press both outer buttons 1 for approx. 20 sec-
onds, maintaining pressure until the LED 2
starts to flash: all stored programs are deleted.
It is not possible to delete individual programs.
Cup holders
Do not place glass containers in the cup
holders; otherwise, there is a danger of
injury in the event of an accident.<
Front
Alternating-code transmitters
Consult the operating instructions of the unit
you wish to set when programming the univer-
sal remote control. You will find information
there on the possibilities for synchronization.
When programming hand-held transmitters
that employ an alternating code, please follow
these additional instructions:
Programming will be easier with the aid of
a second person.<
Depending on your optional equipment, the
center console contains either one or two cup
holders.
1.
2.
Park your vehicle within the range of the
remote-controlled equipment.
Passenger side*
Program the integrated universal remote
control as described above in the section on
Fixed-code hand-held transmitters.
3.
4.
Locate the button on the receiver of the
equipment to be set, e.g. on its drive unit.
Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.
5.
Press the programmed memory button 1
of the integrated universal remote control
three times.
The cup holder for the front passenger is
located beneath the air vent.
66
Online Edition for Part No. 01 41 0 012 213 - © 02/06 BMW AG
Categories | BMW Manuals, BMW X3 Manuals |
---|---|
Tags | BMW E83, BMW X3 2.5i, BMW X3 3.0i, BMW X3 Manuals |
Model Year | 2006 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(2 votes, average: 4.5 out of 5) Automotive readers have rated 2006 BMW X3 2.5i 3.0i E83 Owners Manual 4.5 out of 5.0 based on 2 product reviews.
I was after a 2007 manual but a 2006 manual is fine. great stuff
Excellent reference. Thank you