Driver Controls
Note: There are 30 seconds in which to initiate Step 8.
Return to the vehicle and firmly press, hold for two seconds and
8.
release the HomeLink button. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLink should now activate your rolling code equipped device. To
program additional HomeLink buttons begin with Step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink atwww.homelink.com or1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink to accept the signal
from the hand-held transmitter.
After completing Steps 1 and 2
outlined in the“Programming”
section, replace Step 3 with the following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•
Continue to press and hold the HomeLink button (note Step 3 in the
“Programming” section) while you press and release —everytwo
seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink. The indicator light will
flash slowly and then rapidly after HomeLink accepts the radio
frequency signal.
•
Proceed with Step 4 in the “Programming” section.
51
2006
Taurus(tau)
OwnersGuide(post-2002-fmt)
USA(fus)
| Categories | Ford Manuals, Ford Taurus Manuals |
|---|---|
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Automotive readers have rated 2006 Ford Taurus Owners Manual 5.0 out of 5.0 based on 2 product reviews. Thank God I found you. Helped me out of a bad spot. Thank you, thank you . Thank you.
Excelent help. Thanks.