Controls in detail
Useful features
Operation of integrated remote control
Erasing the integrated remote control
memory
Programming tips
̈
̈
Switch on the ignition (୴ page 36).
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:
̈
Switch on the ignition (୴ page 36).
Select and press the appropriate inte-
grated signal transmitter button (2,
̈ Simultaneously press and hold down
the outer signal transmitter buttons 2
and 4, for approximately 20 seconds,
until the indicator lamp 1 flashes rap-
idly. Do not hold for longer than
3
or 4) to activate the remote con-
ț
Check the frequency of the hand-held
remote control 5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 288-399 MHz.
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
30
seconds.
20
seconds.
The codes of all three channels are
erased.
ț
ț
Put a new battery in the hand-held re-
mote control 5. This will increase the
likelihood of the hand-held remote con-
trol sending a faster and more accurate
signal to the integrated remote control.
i
If you sell your vehicle, erase the codes
of all three channels.
While performing step 3, hold the
hand-held remote control 5 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or 4) you
are programming. Attempt varying an-
gles at the distance of 2 to 5 inches
(5
to 12 cm) away or the same angle at
varying distances.
252
Product Specification
Categories | Mercedes-Benz Manuals, Mercedes-Benz SL-Class Manuals |
---|---|
Tags | Mercedes-Benz SL, Mercedes-Benz SL500, Mercedes-Benz SL55 AMG, Mercedes-Benz SL600, Mercedes-Benz SL65 AMG |
Model Year | 2006 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Thanx for this information. Having problems with insurance and warrantee