Driving tips
Reprogramming a single
HomeLink button
To program a device to HomeLink using
a HomeLink button previously trained,
follow these steps:
Gate operator programming &
canadian programming
Accessories
If you would like additional information on
the HomeLink Wireless Control System,
HomeLink compatible products, or to
purchase other accessories such as the
HomeLink® Lighting Package, please
contact HomeLink at 1-800-355-3515 or
on the internet at www.homelink.com.
During programming, your hand-held
transmitter may automatically stop trans-
mitting. Continue to press and hold the
HomeLink button (note steps 2 through 4
in the “Programming” portion of this text)
while you press and re-press (“cycle”)
your handheld transmitter every two sec-
onds until the frequency signal has been
learned. The indicator light will flash
slowly and then rapidly after several sec-
onds upon successful training.
1.
Press and hold the desired HomeLink
button. Do NOT release until step 4
has been completed.
2.
When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter 3~7 cm away
from the HomeLink surface.
This device complies with Industry
Canada Standard RSS-210. Operation
is subject to the following two conditions:
1. This device may not cause interfer-
ence, and
2. This device must accept any interfer-
ence, including interference that may
cause undesired operation of the
device.
3.
4.
Press and hold the hand-held trans-
mitter button (or press and “cycle” - as
described in “Canadian Programming” ✽ NOTICE
above).
If programming a garage door opener
or gate, it is advised to unplug the device
during the “cycling” process to prevent
possible motor burn-up.
The HomeLink indicator light will flash,
first slowly and then rapidly. When the
indicator light begins to flash rapidly,
release both buttons.
WARNING
The previous device has now been
erased and the new device can be acti-
vated by pushing the HomeLink button
that has just been programmed.This pro-
cedure will not affect any other pro-
grammed HomeLink buttons.
Changes
or
modifications
not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
IC: 4112104541A Gentex
MODEL/FCC ID: NZLSTDHL3
5
29
| Categories | Kia Amanti Manuals, Kia Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)