Lamps in luggage compartment lid
3.
Pull out the bulb holder for the backup
lamp 1 or brake lamp 2 downward.
License plate lamp
5-watt bulb, C5W
1.
Insert screwdriver into the slot and press to
the right, refer to arrows. This releases the
lamp.
4.
Backup lamp: remove the bulb for replace-
ment.
Brake lamp: apply gentle pressure to the
bulb while turning it to the left for removal
and replacement.
2.
Remove the lamp and replace the bulb.
Changing wheels
Sports Wagon:
Brake lamp and backup lamp
Safety precautions in the event of a flat
tire or wheel change: park the vehicle as
far as possible from passing traffic and on solid
ground. Switch on the hazard warning flashers.
Have all vehicle occupants get out of the vehicle
and ensure that they remain outside the imme-
diate area in a safe place, such as behind a
guardrail.
1.
Turn the locks to the left and fold down the
trim.
If a warning triangle* or portable hazard warning
lamp* is required, set it up on the roadside at an
appropriate distance from the rear of the vehi-
cle. Comply with all safety guidelines and regu-
lations.
Change the wheel only on a level, firm surface
which is not slippery. The vehicle or the jack
could slip to the side if you attempt to raise the
vehicle on a soft or slippery surface such as
snow, ice, tiles, etc.
2.
Fold down the foam insulation.
Position the jack on a firm support surface.
Do not use a wooden block or similar object as a
support base for the jack, as this would prevent
it from extending to its full support height and
reduce its load-carrying capacity.
To avoid serious or fatal injury: never lie under
the vehicle, and never start the engine while it is
supported by the jack.<
248
Online Edition for Part no. 01 41 2 600 310 - © 02/08 BMW AG
| Categories | BMW 5-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 525i, BMW 525xi, BMW 530i, BMW 530xi, BMW 550i, BMW E61 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)