Preparation
Your BMW has a special nut as body ground
or negative terminal.
1.
Check whether the battery of the other
vehicle has a voltage of 12 Volts and
approximately the same capacitance in Ah.
This information can be found on the bat-
tery.
2.
3.
Switch off the engine of the assisting vehi-
cle.
Switch off any electrical systems and com-
ponents in both vehicles.
There must not be any contact between
the bodies of the two vehicles, otherwise
there is a danger of shorting.<
5.
Attach the second end of the cable to the
negative terminal of the battery or to the
engine or body ground of the vehicle to be
started.
Connecting jumper cables
To avoid personal injury from sparks, fol-
low this sequence when connecting
jumper cables.<
Starting engine
1.
Start the engine on the assisting vehicle
and allow it to run at idle for several minutes
at slightly increased speed.
In your BMW, the so-called jump-starting termi-
nal in the engine compartment serves as a pos-
itive terminal for the battery, also refer to engine
compartment overview on page 233. The cover
cap is marked with a +.
2.
Start the engine on the other vehicle in the
usual way.
If the first starting attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.
1.
Fold open the cover of the BMW jump-
starting terminal. To do so, pull the tab.
3.
4.
Let the engines run for a few minutes.
Disconnect the jumper cables by reversing
the connection sequence.
Check the battery and recharge if necessary.
Never use spray fluids to start the
engine.<
Tow-starting and towing
2.
Attach one end of the jumper cable plus/+
to the positive terminal of the battery or a
jump-starting terminal of the vehicle provid-
ing assistance.
Observe applicable laws and regulations
for tow-starting and towing.<
Do not transport any passengers other
than the driver in a vehicle that is being
towed.<
3.
4.
Attach the second end of the cable to the
positive terminal of the battery or to a start-
ing-aid terminal of the vehicle to be started.
Attach one end of the jumper cable minus/–
to the negative terminal of the battery or to
an engine or body ground of the assisting
vehicle.
Using tow fitting
Always keep the screw-in tow fitting with the
vehicle. It can be screwed in at the front or rear
of the BMW.
255
Online Edition for Part no. 01 41 2 600 721 - © 08/08 BMW AG
| Categories | BMW 5-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 528i, BMW 528xi, BMW 535i, BMW 535xi, BMW 550i, BMW E60, BMW E61 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4.5 out of 5)
Automotive readers have rated 2009 BMW 5-Series 528i 535i XDrive 550i E60 E61 Owners Manual 4.5 out of 5.0 based on 2 product reviews. Feeling great about my downloaded book.
I'm looking for the frozen stuff animals
Very interesting site.
A real gold mine .