4.
5.
Screw dust cap off valve of defective wheel
and screw filling hose 2 of sealant bottle
onto valve.
4.
Correct tire inflation pressure to 29 psi/
200 kPa. With the ignition switched on:
>
Increase inflation pressure: switch on
compressor, position I. To check cur-
rently set inflation pressure, briefly
switch off device.
Insert sealant bottle on compressor hous-
ing so that it is positioned upright.
Do not allow compressor to run
longer than 10 minutes, otherwise
the device will overheat and may be dam-
aged.<
>
Reduce inflation pressure: press
button 8 or turn screw 8 on pressure
gauge.
If the inflation pressure is not held, drive
the vehicle again, refer to Distributing
sealant. Then repeat steps 1 to 4 once.
6.
7.
8.
Make sure that the device is switched off,
position 0.
Using the M Mobility System can be ineffective
in the event of tire damage greater than
approx. 0.16 in/4 mm in size. Please contact the
nearest BMW center, refer to page 232, or a
workshop that works according to BMW repair
procedures with correspondingly trained per-
sonnel if the tire cannot be made ready for driv-
ing with the M Mobility System.<
Insert connector 3 into lighter socket in
vehicle interior, refer to page 109.
With the ignition switched on:
Switch on the device and allow to run for
approx. 3 minutes to fill wheel with sealant.
It is not important what inflation pressure
the tire has after filling.
9.
Switch off device.
The tire inflation pressure must be at least
29 psi/200 kPa. Otherwise do not con-
tinue driving.<
10.
Remove connecting hose from connection
of sealant bottle and tire valve.
Stow the M Mobility System in the vehicle
again.
Continue driving
Do not exceed the permissible maximum
speed of 50 mph/80 km/h, otherwise
accidents can occur.<
Distributing sealant
Immediately drive approx. 2 miles/3 km so that
sealant is evenly distributed in tire.
Reinitialize the Flat Tire Monitor.
For details, refer to page 84.
Do not exceed a maximum speed of
35
mph/20 km/h if possible.<
mph/60 km/h. Do not drop below
Have the defective tire and the sealant bottle of
the M Mobility System replaced as soon as
possible.<
12
Producing tire inflation pressure
1.
2.
3.
After approx. 2 miles/3 km, stop at suitable
location.
Changing wheels*
Screw compressor hose 9 directly onto tire
valve.
Safety precautions in the event of a flat
tire or wheel change: Park the vehicle as
far as possible from passing traffic and on solid
ground. Switch on the hazard warning flashers.
Apply the handbrake and shift into first gear or
reverse with the manual transmission, or move
Insert connector 3 in lighter socket in vehi-
cle interior.
227
Online Edition for Part no. 01 41 2 600 738 - © 08/08 BMW AG
| Categories | BMW 5-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW 550i, BMW E60 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)