What to do in an emergency
9.
Loosen the wheel nuts and
remove them with your fingers.
Slide the wheel off the studs and
lay it flat so it cannot roll away. To
put the wheel on the hub, pick up
the spare tire, line up the holes
with the studs and slide the wheel
onto them. If this is difficult, tip the
wheel slightly and get the top hole
in the wheel lined up with the top
stud. Then jiggle the wheel back
and forth until the wheel can be
slid over the other studs.
OEN066007
OEN066009
7.
Place the jack at the front or rear 8. Insert the jack handle into the jack
jacking position closest to the tire and turn it clockwise, raising the
you are changing. Place the jack vehicle until the tire just clears the
at the designated locations under ground. This measurement is
the frame. The jacking positions approximately 1.2 in (30 mm).
are plates welded to the frame Before removing the wheel lug
with two tabs and a raised dot to nuts, make sure the vehicle is sta-
index with the jack. ble and that there is no chance for
movement or slippage.
WARNING - Jack location
To reduce the possibility of
injury, be sure to use only the
jack provided with the vehicle
and in the correct jack position;
never use any other part of the
vehicle for jack support.
6
16
Product Specification
Categories | Hyundai Manuals, Hyundai Veracruz Manuals |
---|---|
Model Year | 2009 |
Download File |
|
Document Type | Owners Manual |
Language | English |
Product Brand | Hyundai, Veracruz |
Document File Type | |
Copyright | Attribution Non-commercial |