If the system cannot be operated after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions of the original hand-held transmit-
ter or press and hold down the programmed
memory button 1 of the integrated universal
remote control. If the LED 2 on the integrated
universal remote control flashes rapidly for a
short time then lights up for approx. 2 seconds,
this indicates that the original hand-held trans-
mitter uses an alternating-code system. In the
case of an alternating-code system, program
the memory buttons 1 as described in the sec-
tion below on alternating-code hand-held
transmitters.<
If you have questions, please contact your
BMW Sports Activity Vehicle Center.<
Deleting stored programs
Press the left and right memory button 1 for
approx. 20 seconds until the LED 2 flashes rap-
idly:
All stored programs are deleted.
Reassigning individual programs
1.
Hold the original hand-held transmitter at a
distance of approx. 4 in/10 cm to 12 in/
30
cm from the memory buttons 1.
The required distance between the
hand-held transmitter and memory
buttons 1 depends on the relevant system
of the original hand-held transmitter used.<
Alternating-code hand-held
transmitters
2.
3.
Press the desired memory button 1 of the
integrated universal remote control.
Consult the operating instructions of the unit
you wish to set when programming the inte-
grated universal remote control. You will find
information there on the possibilities for syn-
chronization.
When programming hand-held transmitters
that employ an alternating code, please follow
these additional instructions:
When the LED 2 flashes slowly after approx.
20 seconds, press the transmit button of
the original hand-held transmitter. Release
both buttons as soon as the LED 2 flashes
rapidly. If the LED 2 does not flash rapidly
after approx. 15 seconds, then change the
distance and repeat the step.
Programming will be easier with the aid of
a second person.<
Digital compass*
1.
2.
Park your vehicle within the range of the
remote-controlled equipment.
Program the integrated universal remote
control as described above in the section on
Fixed-code hand-held transmitters.
3.
4.
Locate the button on the receiver of the
equipment to be set, e.g. on its drive unit.
Press the button on the receiver of the
device you want to set up. After step 4, you
have approx. 30 seconds for step 5.
5.
Press the programmed memory button 1
of the integrated universal remote control
three times.
1
2
Adjusting button
Display
The display indicates the cardinal or intercardi-
nal direction in which you are currently driving.
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
70
Online Edition for Part no. 01 41 2 602 348 - © 02/09 BMW AG
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW E83, BMW F25, BMW X3 xDrive28i, BMW X3 xDrive30i |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 2 out of 2)
Automotive readers have rated 2010 BMW X3 xDrive28i X3 xDrive30i E83 F25 Owners Manual 2.0 out of 2.0 based on 1 product reviews. I need the manual for BMW 2009.