Hills
Cargo loading
To prevent overheating and reduced effi-
ciency of the brake system, drive long or
To avoid loading the tires beyond their
approved carrying capacity, never over-
load the vehicle. Overloading can lead to over-
heating of the tire and increases the rate at
which damage develops inside the tires. The
ultimate result can assume the form of a sudden
blowout.<
steep downhill grades in the gear in which the
least braking is required. Otherwise, even light
but continuous pressure on the brake can lead
to high temperatures, brake wear and possibly
even brake failure.<
The braking action of the engine can be further
intensified by downshifting, all the way down to
first gear if need be. This strategy helps you
avoid placing excessive loads on the brake sys-
tem. Downshifting in manual mode of automatic
transmission, refer to page 41. When descend-
ing hills slowly, use HDC Hill Descent Control,
refer to page 52.
Make sure that no fluids leak in the cargo
area; as otherwise the vehicle could be
damaged.<
Determining load limit
Never drive with the clutch depressed,
with the transmission in neutral, or with
the engine switched off; otherwise, you will
have neither the braking action of the engine or
nor its power assistance to the brakes or steer-
ing.
Never allow floor mats, carpeting, or other arti-
cles to protrude into the area around the brake
or accelerator pedals and obstruct their move-
ment.<
1.
2.
Locate the following statement on your
vehicle's placard*:
The combined weight of occupants
and cargo should never exceed
XXX lbs. or YYY kg. Otherwise, the vehicle
may be damaged and unstable driving con-
ditions may result.<
Corrosion on brake rotors
When the vehicle is driven only occasionally,
during extended parking periods, and in operat-
ing conditions where brake applications are less
frequent, there is an increased tendency for
corrosion to form on rotors, while contaminants
accumulate on the brake pads. This occurs
because the minimal pressure which must be
exerted by the pads during brake applications
to clean the rotors is not reached.
Determine the combined weight of the
driver and passengers that will be riding in
your vehicle.
3.
4.
Subtract the combined weight of the driver
and passengers from XXX lbs. or YYY kg.
The resulting figure equals the available
amount of cargo and luggage load capacity.
For example, if the XXX amount equals
Should corrosion form on the brake rotors, the
brakes will tend to respond with a pulsating
effect that even extended application will fail to
cure.
990
lbs. and there will be five 150-lb. pas-
sengers in your vehicle, the amount of avail-
able cargo and luggage load capacity is
240
990
lbs.:
lbs. minus 750 lbs. = 240 lbs.
Brake pads
The warning lamp lights up.
The brake pads have reached their min-
imum pad thickness. Have brake pads
replaced immediately.
5.
Determine the combined weight of luggage
and cargo being loaded into and/or onto the
vehicle. This combined weight may not
85
Online Edition for Part no. 01 41 2 602 348 - © 02/09 BMW AG
| Categories | BMW Manuals, BMW X3 Manuals |
|---|---|
| Tags | BMW E83, BMW F25, BMW X3 xDrive28i, BMW X3 xDrive30i |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 2 out of 2)
Automotive readers have rated 2010 BMW X3 xDrive28i X3 xDrive30i E83 F25 Owners Manual 2.0 out of 2.0 based on 1 product reviews. I need the manual for BMW 2009.